Q-See DVR user manual Installation 3.2 Connecting Cameras and TV Monitor

Q-See Q25DVR4ES User's Manual

Press to configure the DVR play/record system.

Press	to print the picture of DVR's playback
Press	to play the video .

Q-See Q25DVR4ES User's Manual

Chapter 3: Installation - 3.2 Connecting Cameras and TV Monitor

There are 4 camera inputs and 1 video output with BNC connectors (Refer to Chapter 2: Layout -2.2 Rear Panel).

1.Connect the camera cables from the camera to the 4 Video Inputs on the DVR.

2.Connect the 4 power feeds for the cameras to the power connectors on the cable near the video ports of the DVR, connect the other end to the power supply and plug the power supply into a surge protector.

3.Using the included RCA to BNC cable, connect the yellow RCA connector from the cable to the RCA video in port on the TV, connect the silver BNC connector on the other end of the cable to the BNC video out port on the back of the DVR.

NOTE: Refer to Chapter 10: Appendix-10.1 System Connection Diagram

Chapter 3: Installation - 3.3 Connecting Power Supply

Please only use the power adapter supplied with the DVR.

Connect the power cord to a surge protector or Uninterruptible Power

Supply.

Chapter 4: System Boot -4.1 Detecting Installed Hard Drive

After connecting the power, the system will boot-up and detect the installed hard drive.

On the Monitor it will show the hard drive information.

Please refer to the hard drive manual to configure hard drive as Master.

Page 21 Page 6