Q-See QD6002D, QD6001D, QD6003D, QD6502B, QD6501B Connecting the Camera to a Security DVR System

DOME CAMERAS (QD6001D, QD6002D and QD6003D)

STEP 1. The mounting base on the dome cameras will need to be removed prior to installing the camera. The method for removing the base varies by the model:

QD6001D - Using the included hexagonal wrench, unscrew the two bolts from the side of the camera.

QD6001D Base

QD6002D - The base of this camera unscrews from the rest of the body.

QD6003D - Using the included hexagonal wrench, unscrew the three hex screws located around the sides of the camera.

QD6003D Base

STEP 2. Once the base has been removed, position it where you want to mount the camera and use it as a template to mark where to drill the holes for the included mounting screws.

STEP 3. Remove base and drill out holes STEP 4. Insert plastic expanders into holes

STEP 5. Use included screws to mount base to surface. STEP 6. Attach camera to base.

BULLET CAMERAS (QD6004B, QD6005B, QD6501B, QD6502B and QD6503X)

STEP 1. At the desired location, use the included mounting template to drill the holes for the mounting screws

STEP 2. Insert the plastic expanders into the holes STEP 3. Mount the camera using the included screws.

QD6503X

This indoor camera requires a screw-type mounting rod (available separately)

STEP 1. Install the rod mount as directed.
STEP 2. Attach the included mounting
bracket to the underside or top of the
camera as needed with the included
screws
STEP 3. Attach camera to mounting rod.	QD6503X Mounting Bracket

CONNECTING THE CAMERA TO A SECURITY DVR SYSTEM

CAMERA

STEP 1. Connect the BNC and power leads from the camera to the matching connectors on one end of the power and video cable.

The QD6503X requires a special adapter (included). The two bare wire ends must be inserted into the Positive (+) and Ground ( ) ports on the power input box at the back of the camera. The power cable plug connects to the attached female power jack on this adapter.

IMPORTANT! When connecting the power and video cable between the camera and the DVR, the “male” power end (red plug in the illlustration) connects to the matching power lead on the camera.

STEP 2. For multi-camera packs, connect the power lead on the other end of the cable to the plug from the power splitter. Or, if your package includes a power distribution panel, connect the power lead to one of the power jacks on the panel. Proceed to Step 4, below.

For single camera packages, connect the power lead to the power adapter itself. In this case, you may skip to Step 4.

STEP 3. Connect the power lead on the power splitter to the camera power adapter. DO NOT plug the adapter into an outlet at this time.

STEP 4. Connect the BNC connector on the other end of the video/power cable to a Video In port on the back of the DVR.

Repeat Steps 1 through 4 for all cameras before continuing.

STEP 5. Plug the power adapter into a surge protector* or turn on the power panel.

*When selecting a surge protector, it is STRONGLY recommended to use one that is UL-1449 rated, for a clamping voltage of 330 or lower, a Joule rating of at least 400 and a response time of 10 nanoseconds or less.

8 9