Q-See QSD2014 User’s Manual 5.7 Record Schedule, Sensor Setup, Motion Detector Setup

QSD2014 User’s Manual

5.7 Record Schedule

Setting the Record Schedule allows you to customize the type of recording you want to use depending on

the time of day.

Record Schedule

AMPM

0… 3… 6… 9… 0… 3…. 6… 9…

NO-RECORD

NORMAL-RECORD

S SENSOR -RECORD

() MOVE (SEL) SELECT (MENU) EXIT

The time line indicates 24 hours of a day based on AM/PM (0=12).

Press [▲，▼，◄◄ and ►►] buttons to select a time point, press [SEL] to modify the recording mode.

NO-RECORD[WHITE ]:DVR will not record during this period.

NORMAL RECORD [RED]:DVR will record continuously during this period. SENSOR RECORD [ S ]:DVR will record when sensor or motion is triggered

Note: In order to activate the record schedule, please press [REC] button to start Record schedule, otherwise, DVR will not start recording.

5.8 Sensor Setup

SENSOR SETUP

SENSORED RECORD TIME	30
ALARM ON TIME	05

MOTION DETECTOR SETUP

( ) MOVE (SEL)SELECT (MENU)ESC

Sensor Record Time indicates how long the recording file remains open after the motion ends. After this time the next alarm starts a new file.

Alarm on time indicates how long the buzzer will sound when motion is detected.

CONT: Continuous alarm until any key is pressed…

OFF: No alarm

Note: Sensored Record Time and Alarm On Time are measured in seconds.

5.9 Motion Detector Setup

This section allows you to set up motion detection options for each camera.

Motion Detector Setup

CH1	ON	Level	2	Area
CH2	ON	Level	2	Area
CH3	ON	Level	2	Area
CH4	ON	Level	2	Area

() MOVE (SEL)SELECT (MENU)ESC

On/off: Enable or disable motion detection recording.

Level: Sensitivity for motion detection. There are 3 levels of sensitivity: Level 1 to 3 with 3 the highest.

8Area: Select detectable area on the screen.