ASSEMBLING THE CASING
A.Remove the outlet and return stubs from the cardboard box inside the loading/combustion chamber, and install them
B.Fit a screw and nut in the holes on the four bottom brackets (1), without tightening them
C.Insert them in the top of the four slots provided at the bottom of the boiler, and secure them with the nuts.
NOTE:
The four top brackets (2) have holes for fastening the paneling to the
D.Fit a bolt and nut in the holes on the four bottom brackets (1), without tightening them
E.Insert them in the four slots at the bottom of the boiler and tighten them
F.Insert the four top brackets (2) on the studs and tighten them with the nuts (3)
G.Apply the insulation (4) around the boiler body
H.Fit the side panels (5), hooking the slots (6) on the bottom of the panels to the bottom brackets (1)
I.Fasten the panels (6) to the top brackets (2) using the screws (7) supplied with the casing. Leave the right side loose after removing the plug in the top of rear section
J.Fit the top rear panel (8), resting it on the side panels, and secure it with two screws (9)
K.Apply the rear insulation (10), inserting the edges in the openings at the side and top
L.Fit the rear panel (11) and fasten it with the six screws (12) supplied
M.Insert the top centre panel (13) underneath the top rear panel (8) and rest it on the side panels
19
