Quadra-Fire 3100 owner manual PEDESTAL/LEG KIT Installation, Pedestal Model

PEDESTAL/LEG KIT INSTALLATION

WARNING: DO NOT OPERATE YOUR QUADRA-FIRE STOVE BEFORE FULLY ASSEMBLING ALL COMPONENTS. BURNING YOUR STOVE WITHOUT A PEDESTAL OR LEG KIT ATTACHED WILL VOID YOUR WARRANTY, AND COULD PRESENT A SAFETY HAZARD.

PEDESTAL MODEL

1.Place protective pad or stove pallet on floor.

2.Lay body of stove on its back on protective pad or pallet.

3.Slide pedestal over adapter on bottom of stove

4.Line up holes in sides of pedestal with holes in adapter.

5.Bolt pedestal into place, and tighten securely.

6.Carefully stand stove up and place in desired location.

7.Slip wooden decorative strips onto pedestal edges.

8.Open door of stove and check to insure firebricks and kaowool blanket are in

their proper locations (see pages 25-26).

Adapter

LEG MODEL

1.Place protective pad or stove pallet on floor.

2.Lay body of stove on its back on protective pad or pallet.

3.Bolt cover piece onto mounting brackets, using outer two mounting holes.

4.Slip washers onto bolts, then bolt legs onto mounting brackets.

5.Screw leg assembly onto adapter on bottom of stove using eight 1/4-20 screws.

6.Carefully stand stove up and place in desired location.

7.Use leveling bolts on legs to stabilize and level stove.

8.Open door of stove and check to insure firebricks and kaowool blanket are in their proper locations (see pages 25-26).

FOR INSTALLATION OF ASH REMOVAL SYSTEM, SEE PAGE 18.

Pedestal

Mounting bracket

Cover piece

Adapter

Leg

Page 17