ASH REMOVAL SYSTEM INSTALLATION
1. Remove ash removal system top and bottom cover plates by loosening nuts under stove.
2. Discard both plates.
3. Insert ash removal system grate into opening in firebox floor.
4. Continue with proper installation according to model you have purchased: pedestal or leg.
PEDESTAL MODEL
1.Place protective pad or stove pallet on floor.
2.Lay body of stove on its back on protective pad or pallet.
3.Line up holes in ash removal system with
holes in adapter on bottom of stove.
4. Screw ash removal system securely in place.
5. Slide pedestal over ash removal system, and line up holes in sides of pedestal with holes in adapter on bottom of stove.
6. Screw pedestal into place, and tighten securely.
7. Carefully stand stove up and place in desired location.
8. Slip wooden decorative strips onto pedestal edges.
9. Open door of stove and check to insure firebricks and kaowool blanket are in their proper locations (see pages
LEG MODEL
1.Place protective pad or stove pallet on floor.
2.Lay body of stove on its back on protective
pad or pallet.
3. Line up holes in ash removal system with holes in adapter on bottom of stove.
4. Screw ash removal system in place.
5. Bolt cover pieces onto mounting brackets, using outer two mounting holes.
6. Slip washers onto bolts, then bolt legs onto mounting brackets.
7. Screw leg assembly onto adapter on bottom of stove using eight ¼”
8. Carefully stand stove up and place in desired location.
9. Use leveling bolts on legs to stabilize and level stove.
10. Open door of stove and check to insure firebricks and kaowool blanket are in their proper locations (see pages
Page 18
