![](/images/new-backgrounds/1025267/2526749x1.webp)
R
Cape Cod Wood Stove
BLOWER INSTALLATION & OPERATION
Part
The blower is shipped fully assembled and ready for installation.
1.Remove the three Phillips head screws and the mounting bar from the outer shield at the lower back of the stove.
2.Align holes in mounting bar with those on mounting plate of blower in order to sandwich the blower mounting plate between the rear shield and the mounting bar.
3.Align screws with holes in rear shield and tighten, securing blower to stove.
4.Do not remove ground prong from plug. Plug blower cord into a grounded outlet. Route power cord away from stove in such a manner to avoid heat from the stove, traffic, or other damage. Do not route cord over or in front of stove.
ADJUSTING THE BLOWER SPEED CONTROL, IF NECESSARY*
NOTE: When the speed control is turned clockwise, it will click on to high speed. Turn the speed control clockwise to decrease the speed. At full clockwise, the blower should blow gently, but should not stop.
INSTALLATION
BLOWER OPERATING INSTRUCTIONS
1.Initial (cold)
2.High burn setting: The blower may be left on throughout the burn.
3.Medium burn setting: The blower should be left off until a good burn is established, then turned on at a medium or high rate.
4.Low burn setting: The blower tends to cool off the stove. Leave blower off until burn is well established. Then turn on at your desired rate.
5.The highest blower speed is obtained by turning the speed control on and then adjusting back towards off as far as possible without turning the blower off. For a low blower speed, turn the control knob clockwise as far as possible.
*The blower speed control for this unit is adjusted at the factory, and normally does not require further adjustment.
1.With the unit plugged in, turn the speed control knob to slow (full clockwise).
2.With a small screwdriver, adjust the blower speed by turning the adjustment mechanism through the hole on the side of the speed control.
3.Adjust the speed so the blower runs slowly, but does not stop. Turn clockwise to slow the blower and counterclockwise to increase the speed.
Rear
Shield
Blower mounting plate
Mounting |
bar |
32198A February 15, 2002 | Page 25 |