Quadra-Fire 5100I-NL-B warranty Blower Cord Location, Disconnect the appliance from power supply

R

5100-I ACT WOOD INSERT

B. Blower Cord Location

The 5100-I Insert comes standard with 2 blowers, installed at the factory with the power cord on right side of insert (as you face the unit). Do not route the power cord under or in front of appliance.

The power cord can also be installed on the left side. Follow instructions below.

Green grounding wire	White wire into Red Connector
Black wire into Blue Connector
Left Blower
Snap Disc	Right Blower
Red
Connector	Snap Disc
Blue
	by-pass
Connector	switch
	Speed Control
	(Rheostat)

Figure 12.1 - Blower Assembly Components

1.Disconnect the appliance from power supply.

2.Remove the grille following instructions on page 11.

3.Unplug the blower cord wires from the wire harness.

4.Remove green grounding wire from grounding screw.

5.Using a pair of pliers, squeeze the strain relief and remove the blower cord wires and strain relief from the grille.

6.Locate the wire harness wires tucked up under the ash- catcher on the left side of the appliance. Cut the zip tie that is holding the wires in place.

7.Remove the button plug from the left side of grille. Thread the blower cords wires through the hole and snap the strain relief in place. Figure 12.3.

8.Attach grounding wire to ground screw.

9.Connect the white blower cord wire to the red connector on the wire harness.

10.Connect the black blower cord wire to the blue connec- tor on the wire harness.

11.Tuck the wire out of the way of the blower motor.

12.Re-install grille.

NOTE: Each wire has a label to denote which component it connects to.

				Blower cord attached to
				right side of grille.
				Strain Relief
Bottom	ofgrille			Blower cord
				Green
				grounding wire
				White wire
				Grounding
		of	grille	screw
Top				Black wire
				Back view of grille

Figure 12.2

	Remove button plug
grille
of
Bottom
grille	Grounding screw
of
Top	Back view of left
	side of grille

Figure 12.3

Caution

Shock hazard.

• Do NOT remove grounding prong from plug.

•Plug directly into properly grounded 3 prong receptacle.

•Route cord away from appliance.

•Do NOT route cord under or in front of appli- ance.

Page 12 438-0380E April 21, 2010