Quadra-Fire 5100I-GD-B, 5100I-NL-B Glass Replacement Door Assembly, Glass Replacement Side Window

5100-I ACT WOOD INSERT

R

C.Glass Replacement - Door Assembly

•Frequency: As needed

•By: Homeowner / Qualified service technician

•Task: See the following instructions.

1. Ensure that the fire is out and the appliance is cool to the touch.

2.Protect a table or counter top with padding or towels.

3.Remove the door with the broken glass by lifting the door up and off of the hinges.

4.Lay door face down on a table or counter making sure the handle hangs over the edge so the door lays flat, on a soft surface.

5.Remove the screws from each glass retainer and remove the glass. (If screws are difficult to remove, soak with penetrating oil first).

6.Center the new glass with edges evenly overlapping the opening in the door, (i.e. same space top and bottom, left and right sides).

7.Replace the glass retainers. Be careful not to cross thread the screws.

8.Tighten each retainer just a few turns until each is secured. Check again for centering of glass in door frame. Continue to tighten each retainer alternately, a few turns at a time, until the glass is secure. DO

NOT OVERTIGHTEN.

9.Replace the door on the appliance.

Quadra-Fire stoves are equipped with ceramic super heat- resistant glass, which can only be broken by impact or misuse. Do not slam stove door or impact the glass. When closing door, make sure that logs do not protrude against the glass. Inspect glass regularly. If you find a crack or break, immediately put the fire out and return the door to your dealer for replacement of glass before further use.

WARNING

Handle glass with care.

• Inspect the gasket to ensure it is

Glassundamaged.

Assembly

• Do NOT strike, slam or scratch glass.

• Do NOT operate appliance with glass

&door assembly removed.

•Do NOT operate with glass cracked, broken or scratched.

WARNING

Fire or Injury Risk

•Use only glass specified in manual.

•DO NOT REPLACE with any other material.

D. Glass Replacement - Side Window

•Frequency: As needed

•By: Homeowner / Qualified service technician

•Task: See the following instructions.

1. Open door and remove vertical brick in the bay window area.

2.Reach inside firebox and loosen 4 hex bolts using a 3/8 inch socket wrench holding the cast in place.

3.Only remove the 2 bolts, top and bottom on the side closest to the firebox opening. Figure 33.1.

4.Open the side of the window where the bolts have been removed and slide out glass.

5.Slide new glass in making sure it slides into the cast grooves.

6.Re-assemble in reverse order. Do not overtighten bolts.

Slide Window In / Out

Loosen
	Remove
bolts
	bolts

Figure 33.1

April 21, 2010 438-0380E Page 33