5100-I ACT WOOD INSERT
R
E.Zero Clearance Adjustable Trim Support
Size: 12” d x 50” w, 2-10” h
Included in Kit: | Tools Needed: | |
(1) Trim top | Phillips head screwdriver | |
(1) | Trim front | Sheet metal shears |
(2) | Trim sides | Measuring tape |
Gloves | ||
(already installed)
1.The 10 screws on each set of scissors will already be loose when shipped. Figure 23.1.
2.Expand scissors to desired height. Tighten screws to hold in place using Phillips Head screwdriver. Figure 23.2.
3.Measure front and side trims to required height to cover scissors and mark pieces for cutting. Cut excess mate- rial from top of trim’s edge, not bottom. This edge will be sharp; wear gloves to prevent injury to your hands.
Figure 23.2.
4.Using sheet metal shears, cut trim along the marked edge. The cut edge fits under lip of top trim, so it allows for some variance in your straight edge.
5.The
Adjustments are extremely difficult once trim has adhered to tape. Do a dry run first without removing paper from tape.
6.Place cut edge of trim under top lip and into position on scissors. Place side pieces on first and then front piece. The front piece overlaps side pieces.
7.Once you are satisfied with the positioning, remove trim and set aside.
8.Remove the paper from
NOTE: 3/8 inch (9.5mm) thick tile or like material can be cut to size and fit under lip of top trim edge for a decorative touch.
Figure 23.3.
CAUTION
Sharp Edges
• Wear protective gloves during installation.
EXPLODED VIEW OF SCISSORS | |
| SCREWS ARE CIRCLED |
D O U B L E | D O U B L E |
Figure 23.1
EXPAND SCISSORS TO DESIRED HEIGHT |
|
| CUT TOP EDGE OF TRIM, |
INSTALL FRONT TRIM LAST. | NOT BOTTOM EDGE |
CORNERS OVERLAP SIDE |
|
TRIM PIECES |
|
Figure 23.2
Decorative tile may
be installed
Figure 23.3
Figure 23.4
April 21, 2010 | Page 23 |
