CHAPTER 2. INSTALLATION
Example to set up DTE speed 57600 bps and modulation V.22 bis,
1.Set Normal / Config. Switch to PUSH position for Config. mode.
2.Set desired DTE speed 57600 bps Method:
Toggle the Menu Switch to Menu 4 (DTE speed menu), the digit ‘4’ is shown on the LED segment. Then toggle the Function Switch to Function 2 (speed 57600 bps is selected), the digit ‘2’ is shown on the LED segment. Then press the Enable Switch to update the DTE speed, The character ‘U’ is shown on the LED segment and all parameters will be saved to profile 0 automatically.
3.Set modulation V.22 bis Method:
Toggle the Menu Switch to Menu 3 (modulation menu), the digit ‘3’ is shown on the LED segment. Then toggle the Function Switch to Function 4 (V.22 bis is selected), the digit ‘4’ is shown on the LED segment. Then press the Enable Switch to update the modulation setting, the character ‘U’ is shown on the LED segment and all parameters will be saved to profile 0 automatically.
4.If more settings are required (i.e tx level, flow control, etc), repeat the above steps. The above features were saved to profile 0 automatically).
5.To finish configuration by setting the Normal / Config. Switch to POP position.
ACTIVE Professional External Modem User’s Manual | 8 |
|