APPENDIX A. AT COMMANDS
*The "star" digit (tone dialling only)
#The "gate" digit (tone dialling only)
JPerform MNP 10 link negotiation at the highest supported speed for this call (Optional)
KEnable power level adjustment during MNP 10 link negotiation for this call (Optional)
LDials the last dial string that was dialled
P | Use pulse dialling |
T | Use DTMF dialling |
R | Reverse mode. Allow the modem to call an |
| modem by forcing the call into "answer mode". Must be |
| entered as the last character of the command string (optional). |
!Cause the modem to go
@Cause the modem to listen for 5 seconds of silence
WWait up to the period of time specified in register S7 for dial tone before dialling
| , | Pause for the value specified by register S8 during dial |
| |
| ; | Return to Command State after dialling |
|
|
| ^ | Turn on calling tone |
|
|
| () | Ignored, may be used to format the dial string |
|
|
| - | Ignored, may be used to format the dial string |
|
|
| <space> | Ignored, may be used to format the dial string |
|
|
| S=n | Dial number previously stored in directory location n using | ||
|
| AT&Zn command |
|
|
ATE * | Command echo | Default : | 1 | |
| ATE0 | Inhibits the echoing of commands |
|
|
| ATE1 | Enables the echoing of commands |
|
|
ATHn | Default : | 0 | ||
| ATH0 | Cause the modem to go |
|
|
| ATH1 | If modem is | ||
|
| response, and waits for further commands |
|
|
ATIn | Identification |
|
| |
| I0 | Reports product code |
|
|
| I1 | Reports |
|
|
| I2 | Computes checksum and compares it with value stored in | ||
|
| ROM. Reports result as OK or ERROR. |
|
|
| I3 | Reports firmware revision |
|
|
| I4 | Reports OEM defined identifier string |
|
|
| I5 | Reports Country Code parameter |
|
|
| I6 | Reports firmware revision |
|
|
| I7 | Reports modem data pump model |
|
|
ACTIVE Professional External Modem User’s Manual | 13 |
|