Quantum 560UF/D, 560UF/L O/A, T/D, Menu, Normal, Config, Enable, Function, 5.Reset switch, Normal / Config, Normal / Config, Use T/D Switch to dial

CHAPTER 2. INSTALLATION

a.If the modem is in Normal mode, it acts as a O/A switch. Toggle this switch causes the modem to change from Originate mode to Answer mode and the LED segment displays ‘A.’ for answer mode, or ’O.‘ for Originate mode.

b.If the modem is in Config. mode, it acts as an Enable switch. Toggle this switch causes the modem to execute the selected features and LED segment shows 'U'. The features (except menu 7) were saved to NVM profile 0 automatically (please refer to the section ‘modem configuration').

5.Reset switch

–Press to reset the modem during unexpected software hung-up.

Use T/D Switch to dial

1.Store a 36-digit dial string in the specified entry (n =1-3) for later dialing (AT&Zn=<T or P><tel. no> , n=1-3, i.e AT&Z1=T123456 for tone dial, AT&Z1=P123456 for pulse dial).

2.Set Normal / Config. Switch to PUSH position for configuration mode.

3.Toggle the Menu Switch to the desired Menu 7.

4.Toggle the FunctionSwitch to the desired Function (n=1-3).

5.Press the En Switch to execute the selected features. The character ‘U’ is shown on the LED segment.

6.Set Normal / Config. Switch to POP position.

7.Press the T/D Switch to dial the specific entry (Dial number previously stored in directory location n using AT&Zn).

ACTIVE Professional External Modem User’s Manual 5