Quantum Data 700 Series manual Computer Interfaces, Dvi-I

Computer Interfaces

DVI-I		1		8	C1 C2
	9			16	C5
		17		24	C3 C4
Pin	Signal		Pin	Signal
1	TMDS data 2-		16	Hot plug detect
2	TMDS data 2+		17	TMDS data 0-
3	TMDS data 2/4		18	TMDS data 0+
	shield		19	TMDS data 0/5
				shield
4	TMDS data 4-		20	TMDS data 5-
	shield		21	TMDS data 5+
5	TMDS data 4+		22	TMDS clock shield
6	DDC clock		23	TMDS clock+
7	DDC data		24	TMDS clock-

8Analog vertical sync

9 TMDS data 1-

10	TMDS data 1+
11	TMDS data 1/3	C1	Analog red
	shield
12	TMDS data 3-	C2	Analog green
13	TMDS data 3+	C3	Analog blue
14	+5V power	C4	Analog horz sync
15	Ground	C5	Analog ground

DVI interface on 700 outputs analog signals only, using included DVI-to-VGA adaptor.

S-Video

Chrominance (C) Luminance (Y)

GroundGround

NTSC/PAL BNC

NTSC/PAL RF

(Active on 701 only)

Stereo Audio - 3.5 mm phone jack

Tip	Left channel (1 KHz)
Ring	Right channel (2 KHz)
Sleeve	Ground

RS-232 9-Pin D-Sub Plug

Pin	Signal	Factory defaults
1	No connection	9600 baud
2	Data in (Rx)	8 data bits
3	Data out (Tx)	No parity
4	DTR out	1 stop bit
5	Ground	X on - X off

6No connection

7 RTS out

8 CTS in

Pinout same as for 9 pin PC-AT serial port connector

External DC Power /

Battery Recharge Input

Center pin:	+12.0 VDC
Outer sleeve:	- (Ground)

Warning: Using an external power source other than the Quantum Data supplied AC power supply may injure the operator and damage the generator.

4