Quatech T802.11b/g, WLNG-ET Series End Cap Layout, Ethernet/Power, RP-SMA Male, Name Description

Hardware Installation

Indicator LEDs

The Heavy-Duty Bridge has four indicator LEDs for viewing its current status and connections (see Figure 5). These indicators allow for monitoring and troubleshooting of the Bridge. They also indicate the Bridge’s power-up status, link, connection, and data-activity status. Table 3 describes the status of the indicator LEDs.

Table 3. AirborneDirect™ Heavy-Duty Ethernet Bridge Indicator LEDs

CONN LINK CFG POST

Name	Description
POST	Power on self test completed
CFG	Device has a valid IP address
LINK	Device has successfully
	associated/authenticated with an AP.
CONN	TCP/IP connection established with
	device.

End Cap Layout

The connectors required to attach to the device are:

Ethernet/Power:	Deutsch DTM-06-12SSA
RF:	RP-SMA (Male)

Note: FACTORY RESET hole is optional, if a sealed enclosure is required.

Figure 7. End Cap Pin-out and Connector Location

100-8007-141G AirborneDirect™ Ethernet Bridge User's Guide Page 15

Quatech, Inc. Confidential