Linear DVS-2400 manual Basic Console Programming, Start In Test, MASTER USER CODE 1 GONG & 5 BEEPS

6.BASIC CONSOLE PROGRAMMING

✦In a new installation, when power is first applied the system's master user code is “1234”.

CREATE THE MASTER USER CODE

✎NOTE: Local programming must be entered on the Console's keypad, not on a wireless remote keypad.

1.Press(clears keypad if any other keys have been pressed).

2.Place the Console in Test Mode (enter 1234 and press TEST.

✴A “gong” and four “beeps” will sound.

3.Enter the Setup Mode from Test Mode, enter 1234 then press TEST again.

✴A “gong” and fi ve “beeps” will sound. The system is now in Test Mode.

4.Enter 99 then press HOME.

5.Enter any combination of 1-5 digits for the master user code, then press AWAY.

✎NOTE: For maximum security, a three to five digit code is recommended.

6.Press and hold the OFF key for 3 seconds to exit program mode.

7.Test the new master user code by entering it then pressing TEST.

8.Log the master user code in the box below.

MASTER USER CODE:

✎NOTE: The master user code can be used to enter Setup Mode. The restricted user codes cannot. To create restricted user codes, see the “Advanced Programming” section of this manual.

PROGRAM THE SENSORS INTO THE CONSOLE’S MEMORY

ENTERING

SETUP

MODE

START IN OFF

CLEARS

KEYPAD

DEFAULT

MASTER

USER

CODE

1 GONG &

4 BEEPS (TEST MODE)

DEFAULT

MASTER

USER

CODE

1 GONG &

5 BEEPS (SETUP MODE)

SETTING A

NEW MASTER

USER CODE

START IN SETUP

PROGRAMMING

STEP #99

PROGRAM

NEW

MASTER

USER

CODE

STORE

CODE

HOLD FOR

3 SECONDS TO EXIT SETUP

DONE

✦Each wireless sensor that is going to be used with the Console must be programmed into the Console’s memory.

START IN TEST

1.	Start with the Console in Test Mode (enter any user
	code and press TEST).
2.	Enter the Setup Mode from Test Mode, enter the
	master user code then press TEST again.
	✴ A “Gong” and fi ve “Beeps” will sound.
	✴ The sensor status indicators will light for any sensors
	programmed into the Console.
3.	Enter an unused sensor number from 01-24 (you
	must enter two digits, example: 5 = 05).
	✴ The sensor indicator light will fl ash for the sensor number
	selected.
4.	Activate the sensor by sending a test or alarm
	signal (be sure the sensor's battery is connected or
	that its battery protection strip is removed).
	✴ A single “Bing” tone will sound and the sensor status

TEST

MASTER USER CODE

1 GONG &

5 BEEPS

NEW SENSOR NUMBER

indicator for that sensor will stay lit.

5. Enter another sensor number or exit Setup Mode by

pressing the OFF key for three seconds.

ACTIVATE SENSOR

DONE

12