Linear DVS-2400 manual Console Power Connection, not plug the transformer in until the wiring is

CONSOLE POWER CONNECTION

✦The Console is powered by a low voltage plug-in transformer.

✦Use up to 25 feet of 20 AWG or larger two-conductor wire to connect the transformer to the Console.

1.	Route the power wires from the plug-in transformer
	to the Console.
2.	Connect the wires to the transformer terminals (do
	not plug the transformer in until the wiring is
	complete).
3.	Route the power wires through the Console's wiring
	access hole.
4.	Connect the power wires from the transformer
	to the Console's main terminal block AC & AC
	terminals.
5.	Secure all of the wires entering the Console with a
	zip-tie to the Console’s strain relief loop.

	LINEAR SECURITY CONSOLE MODEL DVS-2400
MAIN
TERMINAL
BLOCK	OPTIONAL
	VOICE MODULE
	MODEL: VB-2

MAIN TERMINAL BLOCK

	AC
	AC
	EXT. SPKR
PLUG-IN TRANSFORMER	(-)
16 VAC, 28 VA	H/A -
	H/A +
	RELAY N.O.
	RELAY DRY

6.	Plug transformer into an unswitched AC outlet.
7.	Secure transformer with screw to prevent
	unplugging.

BACKUP BATTERY INSTALLATION (OPTIONAL)

✦A 12-volt backup battery may be installed and is highly recommended.

✦The backup battery will power the Console for up to 6 hours during AC power loss.

✦The backup battery is automatically charged by the Console when AC power is present.

✦A low backup battery will cause the Console POWER indicator to fl ash as it is being charged.

1.To install the battery, slide the battery between the retaining clamps and under the battery holder.

2.Position the battery until the clamps snap in place. The battery terminals should be facing the center of the Console case bottom.

3.Connect the black battery lead to the negative battery terminal.

4.Connect the red battery lead to the positive battery terminal.

✎WARNING: DO NOT REVERSE THE BATTERY LEADS! THE BATTERY FUSE WILL BLOW.

CONNECT TRANSFORMER LEADS

TO AC POWER TERMINALS

PLUG TRANSFORMER

INTO 115 VAC OUTLET

THAT IS NOT CONTROLED

BY A LIGHT SWITCH

SCREW

115 VAC OUTLET

TRANSFORMER

SLIDE BACKUP BATTERY

INTO BATTERY CLAMPS

CONNECT RED BATTERY LEAD TO RED TERMINAL CONNECT BLACK BATTERY LEAD TO BLACK TERMINAL

CAUTION: DO NOT REVERSE BATTERY LEADS

BATTERY FUSE WILL BLOW

11