Linear DVS-2400 manual Automation Output While Armed, Automation Output During Exit/Entry Delays

AUTOMATION OUTPUT WHILE ARMED

✦The factory setting causes the Console's

Automation Output to activate when pressing the key, or when it's triggered with a two-button remote control.

STEP #73 The Console can be programmed to activate the Automation Output when the system is armed as well as when normally triggered using this step.

7PRS

PROGRAMMING STEP #73

3DEF

HOME PROGRAM

0 FOR STANDARD TRIGGER

1 FOR OUTPUT WHEN ARMED

AWAY STORE PROGRAM

AUTOMATION OUTPUT DURING EXIT/ENTRY DELAYS

✦The factory setting causes the Console's

Automation Output to activate when pressing the key, or when it's triggered with a two-button remote control.

STEP #74 The Console can be programmed to activate the Automation Output during the exit and Entry Delays as well as when normally triggered using this step.

7PRS

PROGRAMMING STEP #74

4GHI

HOME PROGRAM

0 FOR STANDARD TRIGGER

1 FOR OUTPUT DURING EXIT/ENTRY DELAYS

AWAY

STORE PROGRAM

AUTOMATION OUTPUT POLARITY

✦The factory setting causes the Console's Automation Output to provide a current limited voltage source when activated.

STEP #75 The Console can be programmed so the Automation Output provides a current limited voltage source when deactivated using this step.

7PRS

PROGRAMMING STEP #75

5JKL

HOME PROGRAM

0 FOR VOLTAGE WHEN OFF

1 FOR VOLTAGE WHEN ON

AWAY STORE PROGRAM

REMOTE ACCESS PASSWORD

✦This password is used to gain access to the Console when using the RA-2400 remote access software. The password must be 6-digits long.

STEP #87 Use this step to enter a new remote access password then log the password in the box below.

REMOTE ACCESS PASSWORD:

8TUV

PROGRAMMING STEP #87

7PRS

HOME PROGRAM

6-DIGIT REMOTE ACCESS PASSWORD

AWAY STORE PROGRAM

DURESS CODE

✦The duress code will disarm the system, without any special indications or sounds, but will send the programmed duress code to the Central Station. The code should be two or more digits different than any user code

STEP #92 Use this step to enter the duress code then log the code in the box below.

DURESS CODE:

9WXY

PROGRAMMING STEP #92

2ABC

HOME PROGRAM

1-5 DIGIT DURESS CODE (3-5 DIGITS RECOMMENDED)

AWAY STORE PROGRAM

MASTER USER CODE

✦The master user code is 1234 when power is fi rst applied to the Console.

✦The master user code can be changed to any 1-5 digit code. Only the master user can access Setup Mode, restricted users cannot.

✎NOTE: For maximum security, a 3-5 digit code is recommended.

STEP #99 Use this step to enter the new master user code then log the code in the box below.

9WXY

PROGRAMMING STEP #99

9WXY

HOME PROGRAM

1-5 DIGIT MASTER CODE (3-5 DIGITS RECOMMENDED)

AWAY STORE PROGRAM

MASTER USER CODE:

30