13.COMMUNICATOR PROGRAMMING
✦To perform any of the communicator programming steps, the Console must be in the Setup Mode.
✦Each programming function is performed with similar keystrokes. After the Console is in Setup Mode, enter the programming step number and press HOME, then enter the new value and press AWAY. For reference, follow the fi gures next to the programming steps.
✴If the new value is accepted, a “Bing” will sound. If the new value is not accepted, a “Double Buzz” will sound.
SETUP MODE
SETUP MODE
START IN TEST
1.Start with the Console in Test Mode (Setup Mode cannot be reached from any other mode).
2.From Test Mode, enter the master user code then press TEST.
✎NOTE: Only the master user code can be used to put the Console into the Setup Mode. The restricted user codes cannot access Setup Mode, only Code Mode.
✴A “Gong” and fi ve “Beeps” will sound, signaling that the system is in Setup Mode.
3.After programming changes are complete, press the OFF key for three seconds to exit Setup Mode.
✎NOTE: If the Console is left unattended in Setup Mode, it will automatically switch back to Off Mode after three minutes.
TEST
MASTER USER CODE
1 GONG &
5 BEEPS
GENERAL COMMUNICATOR OPTIONS
STEP # | PROGRAMMING |
| POSSIBLE | FACTORY | INSTALLATION |
| FUNCTION |
| VALUES | VALUE | VALUE |
|
|
|
|
| |
76 | 0= NONE; 1 = LISTEN; 2 = | 0 |
| ||
|
|
|
|
|
|
78 | VOICE RESPONSE FROM KEYPAD SPEAKER | 0 | = VOICE RESPONSE DISABLED | 0 |
|
1 | = VOICE RESPONSE ENABLED |
| |||
|
|
|
| ||
|
|
|
|
|
|
100 | REMOTE PROGRAMMING LOCKOUT | 0 | = UNLOCK; 1 = LOCK | 0 |
|
|
|
|
|
|
|
101 | CALL LIMITER | 0 | = OFF; 1 = FIVE CALLS PER ARMING PERIOD | 0 |
|
|
|
|
|
|
|
103 | DIALING DELAY | 0 | = NO DELAY; 1 = 30 SECOND DELAY | 0 |
|
|
|
|
|
|
|
104 | DIALING METHOD | 0 | = TONE; 1 = PULSE | 0 |
|
|
|
|
|
|
|
107 | COMMUNICATOR ENABLE | 0 | = COMMUNICATOR OFF; 1 = COMMUNICATOR ON | 0 |
|
|
|
|
|
|
|
General Communicator Programming Table
32