Linear DVS-2400 manual Console Installation, Console Location, Case Locking Screw, Wall Mounting

5.CONSOLE INSTALLATION

CONSOLE LOCATION

✎NOTE: Wireless sensor signals must be able to reach the Console.

✔Try to centrally locate the Console.

✔Keep Console away from large metal appliances.

✔Maximum recommended sensor range is 400 feet (system tested at 1000 feet).

✎NOTE: If you don't use the Wireless Keypad, the Console should be easily accessible to the usual entrance.

✔When the Console is set in the Away Mode, the user has 30 seconds to switch to Off Mode before the burglary siren sounds.

✎NOTE: Make sure the Console is in a place where the alarm can be heard during the night hours.

✔Optional remote external sirens (up to 150 feet from the Console) can be used to make alarms louder and remote the sound location.

1.Locate the Console near a 115 VAC outlet that's not controlled by a light switch.

2.Locate the Console near a telephone outlet (if using the digital communicator).

CASE LOCKING SCREW

USE A PAPER

CLIP TO REMOVE

THE CLEAR

DISPLAY WINDOW

REMOVE SENSOR

NAMEPLATE TO

ACCESS CASE SCREW

REMOVE CASE LOCKING SCREW TO ACCESS INTERNAL COMPONENTS

✦To access the Console’s internal components or to prepare the Console for wall mounting, the case locking screw needs removing.

1.Use a paper clip to remove the clear plastic display window.

2.Remove the sensor number nameplate.

3.Remove the case locking screw.

WALL MOUNTING

✦If desired, the Console can be surface mounted or recessed into the wall.

FOR RECESSED

WALL MOUNTING ONLY

CUT A 10" x 6 3/4"

HOLE CENTERED BETWEEN STUDS IN MOUNTING WALL AT A CONVENIENT HEIGHT

10"

6 3/4"

Surface Mounting

1.For surface mounting, use the Console’s case bottom as a template and mark the locations for the four mounting screws.

2.Use four screws and appropriate screw anchors to temporarily mount the unit to the wall (the unit will need to be removed to complete the recessed wiring hook up).

Recessed Mounting

1.For recessed wall mounting, cut a 10” by 6-3/4” hole, centered between studs, in the mounting wall at a convenient height.

2.Slide the unit into the mounting hole and temporarily secure it with the two retaining clamps and screws provided (the unit will need to be removed to complete the recessed wiring hook up).

FOR RECESSED

WALL MOUNTING ONLY

SLIDE CONSOLE

INTO WALL OPENING

FOR RECESSED

WALL MOUNTING ONLY

SECURE CONSOLE TO WALL USING THE TWO CLAMPS AND SCREWS PROVIDED

8