Linear DVS-2400 Customizing The System, Activate Sensor Done Start In Test, Number To Remove

11.CUSTOMIZING THE SYSTEM

✦Adding additional sensors will increase the protection provided by the system.

✦All ground-level perimeter openings and accessible upper-story openings need protection.

✦Motion detectors can protect interior areas and areas where valuables are kept.

ADDING SENSORS TO THE SYSTEM

1.	Always start with the Console in Test Mode (enter a
	user code and press TEST).
2.	Enter the master user code then press TEST.
	✴ A “Gong” and fi ve “Beeps” will sound.
	✴ The sensor status indicators will light for each sensor

START IN TEST

programmed into the Console.

3. Enter an unused sensor number from 01-24 (you

must enter two digits, example: 5 = 05).

✎NOTE: A sensor can be programmed into more than one location. Be sure to choose an UNUSED sensor number. If a sensor gets entered into more than one location, delete the duplicates using the remove sensor function.

✴The sensor status indicator light will fl ash for the sensor number selected.

4. Activate the sensor. (To add a wireless keypad,
press the keypad's	key.)
✴ A “Bing” tone will sound when the sensor is programmed

TEST

MASTER USER CODE

1 GONG &

5 BEEPS

NEW SENSOR NUMBER

into the Console and the sensor status indicator will stay lit.
✴ A “Buzz” tone will sound if there is already another sensor
programmed to that sensor number.
5. Enter another sensor number, or exit Setup Mode by
pressing the	key then press OFF for three seconds.

REMOVING SENSORS FROM THE SYSTEM

✦If a previously programmed sensor isn't going to be used with the system anymore, or it's a duplicate that has been entered into more than one sensor location, it should be removed from the Console's memory.

ACTIVATE

SENSOR

DONE

START IN TEST

1.	Start with the Console in Test Mode.
2.	Enter the master user code then press TEST.
	✴ A “Gong” and fi ve “Beeps” will sound.
	✴ The sensor status indicators will light for each sensor
	programmed into the Console.
3.	Enter the sensor number (from 01-24) that you want
	to remove (you must enter two digits, example: 5 =
	05).
	✴ The sensor status indicator light will fl ash for the sensor
	number selected.
4.	Press TEST.
	✴ A “Bing” tone will sound when the sensor has been removed

TEST

MASTER

USER

CODE

1 GONG &

5 BEEPS

SENSOR

NUMBER TO REMOVE

and the sensor status indicator will turn off.
5. Enter another sensor number, or exit Setup Mode by
pressing the	key then press OFF for three seconds.

TEST 1 BING

DONE

22