1.Use a Phillips screwdriver to remove the screw from the battery compartment cover, then remove the cover by press- ing the cover's tab and lifting the cover off.
2.Install three AAA batteries (not supplied) as indicated by the polarity symbols (+ and
3.Replace the cover and the screw. When BATT appears, replace the batteries.
Warning: Dispose of old batteries promptly and properly. Do not burn or bury them.
Caution: If you do not plan to use the phone for a month, remove the batteries. Batteries can leak chemicals that can destroy electron- ic parts.
Cautions:
You must use a Class 2 power
!source that supplies 12V DC and delivers at least 400 mA.
Its center tip must be set to positive and its plug must fit the phone's POWER jack. The supplied adapter meets these specifications.
Using an adapter that does not meet these specifications could damage the phone or the adapter.
•Always connect the AC adapter to the phone before you connect it to AC power. When you finish, disconnect the adapter from AC power before you dis- connect it from the phone.
On a Desk Top
Follow these steps to place the phone on a desk, shelf, or table.
1.Remove the mounting bracket from the bottom of the base by pressing and holding in both tabs, then gently pulling the wide end of the bracket and lifting it off.
SELECTING A LOCATION
You can place the phone on a flat surface such as desk, shelf, or table, or mount it di- rectly on the wall or on a standard wall plate. Select a location that is:
•near an AC outlet
•near the desired telephone line jack(s)
•out of the way of normal activities
•away from electrical machinery, electri- cal appliances, metal walls or filing cabi- nets, wireless intercoms, alarms, and room monitors
Wide End
2.Plug one end of the supplied
L3/L4.
3.Insert the supplied AC adapter's barrel plug into POWER 12VDC 400mA on the back of the phone, then route the adapter cord through the strain relief slot on the bottom of the base.
8 | Installation |
