Radio Shack Audio/ Video Remote Control owner manual Searching for a Code

15-1994.fm Page 48 Tuesday, February 29, 2000 2:04 PM

Problem	Solution
You can turn your	Some audio components might
audio component	need both a Tuner/Receiver code
on and off and	and an Amplifier code to control all
control its vol-	features.
ume, but you can-
not change preset
channels.
Your satellite	The codes listed in this manual are
receiver does not	set up to operate your satellite
respond to the	receiver on the 1st or 2nd addresses
codes listed in the	only.
manual.	Make sure the satellite receiver you
	are setting up can be operated with
	an infrared remote.
The 6-in-One	Some Bang & Olufsen and other
does not operate	manufacturers’ equipment operate
Bang & Olufsen	at frequencies higher than 100 kHz.
audio equipment.	The 6-in-One will not operate such
	devices.

SEARCHING FOR A CODE

If you have tried all the codes from the list and your device still will not respond to the 6-in-One (or if your brand is not listed), try searching for your code.

Follow these steps, using the appropriate device key in Step 1, for each device you need to find. For ex- ample, to find the code for your TV:

1.Turn on your TV, then press TV.

2.Hold down P until the red light blinks twice, then press 9 9 1. The red light blinks twice again.

3.Aim the remote control at the TV.

4.Repeatedly press PWR then TV until the TV turns off.

Need help? Call 1-888-284-8735

48