4.While PAGE and MEMO flash,
repeatedly press TUNING 
or
to select the page where you want to store the frequency.
The page’s number appears under PAGE and the name of the page’s country appears as you
press TUNING 
or 
. For each page, the number of the first available empty memory location in that page flashes next to MEMO.
Note: If you wait more than 10
seconds to press TUNING 
or
, PAGE and MEMO stop flash- ing. If this happens, start again at Step 3.
5.Press ENTER 
to assign the frequency to the flashing memory location. The receiver beeps and a bracket appears around the number where you stored the fre- quency.
Notes:
•If the receiver’s memory is full, MEMOFULL appears when you press a number key.
•To replace a frequency you stored with a new frequency, repeatedly press TUNING 
or TUNING 
to select a new frequency, press M/MEM, then hold down the number key cor- responding to that memory
location for about 2 seconds. The receiver beeps and stores the new frequency in the mem- ory location.
ASSIGNING A NAME TO AN FM/MW/LW STATION OR SW PAGE
To help you easily identify stored fre- quencies, you can assign a name (up to 8 characters) to an FM, MW, or LW memory location, or to an SW page.
1.Select a band (see “Selecting a Band” on Page 18).
2.Repeatedly press PAGE to select the page number where you stored the desired frequency.
3.For an FM, MW, or LW station, use the number keys to enter the desired memory location number.
4.Press EDIT. A cursor flashes under the displayed frequency for about 30 seconds.
5.While the cursor flashes, turn MANUAL TUNING until you see the first character you want to use.
29
