3.Repeatedly press PAGE to select the page where you want to store the frequency. 1 or 2 appears under PAGE.
Notes:
•PAGE flashes only when the receiver is set to SW mode.
•If you wait more than 10 sec- onds to press PAGE, PAGE stops flashing.
•If you pressed ATS/LW in Step 1, PAGE does not appear be- cause there is only one LW page.
4.Press M/MEM. MEMO flashes for about 12 seconds. The number for the first available empty memory location for the selected page flashes next to MEMO.
Note: If an empty memory loca- tion number does not flash, all memory locations are full in the band you selected. If this hap- pens, clear a memory location (see “Deleting a Station You Stored” on Page 30) then store the frequency. Or, to replace a stored frequency with a new fre- quency, repeatedly press TUN-
ING 
or 
to select a new frequency, press M/MEM, then press the number key for the memory location. After a few sec- onds, the receiver beeps and stores the new frequency in the memory location.
5.Press ENTER 
to store the fre- quency in the flashing memory location. The receiver beeps and a bracket appears around the memory location number where you stored the frequency, to show that the frequency was stored there.
STORING SW
FREQUENCIES IN
MEMORY
Follow these steps to store shortwave frequencies into empty memory loca- tions in the shortwave page.
1.Press METER/SW to select the shortwave band.
2.Tune to the frequency you want to store. The currently selected page number appears under PAGE.
3.Press M/MEM. PAGE and MEMO flash for about 10 seconds.
28
