Note: If you wait more than 20 seconds to turn MANUAL TUNING, the cursor stops flashing. If this happens, start again at Step 4.
6.When the character you want
appears, press TUNING 
to move to the next position, then rotate MANUAL TUNING to select the next character.
Note: If you want to correct a character you entered, press TUN-
ING 
to move back to it.
7.When you have finished entering
the name, press ENTER 
.
DELETING A STATION YOU STORED
1.Select a band (see “Selecting a Band” on Page 18).
2.Press ENTER 
.
3.Repeatedly press PAGE until the page with the desired frequency appears.
4.Use the number keys to enter the memory location number.
5.Press M/MEM.
6.Press C (cancel).
LOCKING/UNLOCKING A STORED STATION
After storing your favorite stations, you can lock any of them in memory. This helps you avoid overwriting the station if you accidentally use the receiver’s ATS automatic store feature.
To lock or unlock a station, recall the
station, | press M/MEM then press | ||
| M | . | appears (locked) or dis- |
appears (unlocked).
MOVING A FREQUENCY TO ANOTHER MEMORY LOCATION
Note: These steps show you how to move a frequency to another memory location on the same page. To move the frequency to another memory lo- cation on a different page, follow the steps in “Storing FM, MW, or LW Fre- quencies in Memory” on Page 27 or “Storing SW Frequencies in Memory” on Page 28.
1.Select a band (see “Selecting a Band” on Page 18).
2.Recall the memory location num- ber of the frequency you want to move.
3.Press M/MEM. MEMO and the memory location where the sta- tion is programmed flash.
30
