OPERATION
MAKING AND ANSWERING CALLS
Using the Handset
To make a call, pick up the handset and dial normally. The IN USE indicator flashes when you receive a call and lights while the phone is in use.
Pick up the handset to answer a call and place the handset on the base to end a call.
Note: The corded phone will not operate without AC power. During a power fail- ure, use a backup battery for the base corded phone, or another phone on the same line.
Using the Wireless Headset
1.Place the wireless headset on your head and adjust the headband and microphone for a comfortable fit.
2.Pull down the microphone until it clicks and you hear a dial tone. Dial the desired number using the infra- red remote dial card.
3.To answer an incoming call, pull down the microphone until it clicks and wait about 1 second.
Notes:
•If the headset is on the headset charger and the microphone is pulled down, place the headset on your head, then press PHONE/ FLASH on the infrared remote dial card to answer a call.
•The headset only receives a sig- nal from the remote dial card if the microphone is pulled down. The dial card does not work if the microphone is pulled up.
4.When you finish a call, pull the microphone up until it clicks, or press OFF on the infrared remote dial card, or put the headset back on the headset charger.
Notes:
•The infrared remote dial card only controls the headset, not the corded phone.
•If the headset does not work, move the dial card closer to the sensor on the left side of the headset. If it still does not work, replace the battery in the dial card.
SWITCHING BETWEEN THE HANDSET AND THE HEADSET
Using Hold
To switch from the handset to the head- set, press HOLD on the corded phone, then place the handset on the cradle. The IN USE/BATT. LOW indicator on the headset and the HOLD indicator on the base flash. Put on the headset and pull down the microphone. The HOLD indicator on the base turns off, while the IN USE/BATT. LOW indicator on the headset lights and the IN USE indicator on the base flashes.
14
