Radio Shack TAD-1007 owner manual Using Remote Commands, Press Command Function

43-747.fm Page 19 Friday, August 13, 1999 2:22 PM

USING REMOTE COMMANDS

To use remote commands, you must enter the remote operation security code within 8 seconds after the TAD answers the call. After the TAD beeps once to verify you entered the code correctly, you can enter the number(s) for the function(s) you want the TAD to perform.

Press	Command	Function
0	Stop	Stops message play, message recording, and room
		monitoring.
1	Play Outgoing Message	If an outgoing message is recorded, the TAD beeps
		and says, “Play announcement,” then plays the out-
		going message. After the message plays, the TAD
		beeps once. If no outgoing message is recorded,
		the TAD beeps, then announces, “No announce-
		ment.”
2	Change Outgoing	Records a new outgoing message. When the TAD
	Message	beeps and announces, “Record announcement,”
		begin your new outgoing message. When you fin-
		ish, press 0. The TAD beeps.
3	Room Monitor	Monitors the room where the TAD is located. The
		TAD announces, “Room Monitor.” After 30 sec-
		onds, the TAD beeps and monitoring stops. To stop
		monitoring the room sooner, press 0.
4 1	Play All Messages in a	Plays all the recorded messages. Press 41 for Mail-
4 2	Specific Mailbox (To	box 1, 42 for Mailbox 2, 43 for Mailbox 3, or 44 for
4 3	see what commands	Mailbox 4.
4 4	you can use at this	When messages are recorded, the TAD beeps and
	point, see the table on	announces, “Maibox __” and the number of mes-
	Page 20)	sages, then plays them. If no message is recorded,
		the TAD beeps and says, “Mailbox (number), no
		message.”

19