•Always connect the AC adapter to the TAD before you connect it to AC power. When you finish, disconnect the adapter from AC power before you disconnect it from the TAD.
On a Desk
1.Plug one end of the supplied long modu- lar cord into the TEL. LINE jack on the back of the TAD, then plug the cord's other end into a modular phone line jack.
2.Plug the supplied AC adapter's barrel plug into the AC 9V 400mA jack on the back of the TAD, then plug the other end of the adapter into a standard AC outlet.
When you first connect power, the TAD beeps once, MEMORY TEST appears, and the message counter counts up from 0 to 22. Then the TAD beeps. 0 CALL 0 MES- SAGE appears. OGM1 and OGM2 flash to indicate that no outgoing messages are re- corded.
On a Wall or Wall Plate
Note: To mount the TAD directly on a wall, you need two screws (not supplied) with heads that fit the keyhole slots on the mount- ing bracket. Drill two holes 315/16 inches (100
mm)apart. Then thread a screw into each hole, letting the heads extend about 3/16 inch (5 mm) from the wall.
1.Plug the supplied short modular line cord into the TEL.LINE jack on the back of the TAD.
2.Insert the supplied AC adapter's barrel plug into the AC 9V 400 mA jack on the back of the base.
3.To mount the TAD on a wall plate, route the adapter cord hanging down and the other end of the short modular cord through the center of the bracket. Insert the tabs on the narrow end of the bracket into the slots on the bottom of the base, then push the tab on the wide end of the bracket into the lower slots on the bottom of the base.
Plug the short modular cord's other end into the wall plate jack, align the base's keyhole slots with the wall plate studs, and slide the base downward to secure it.
To mount the TAD directly on a wall, with the power cord and the long modular cords hanging down, insert the tabs on the narrow end of the bracket into the slots on the bottom of the base then push the tab on the wide end of the bracket into the lower slot on the bottom of the base.
Align the TAD's keyhole slots with screws and slide the TAD down to secure it, then plug the modular cord into a modular phone line jack.
4.Slide the handset clip out of its retaining slot, rotate it 180° then slide it back into its slot.
5.Plug one end of the supplied coiled handset cord into the jack on the left side of the base. Plug the other end into the handset's jack. Then place the hand- set on the base.
8 | Preparation | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
