Section Four: Using the Cooktop
USING THE GRILL
CAUTION:
•Use extreme care when placing the grill components into the grill compartment. Avoid contacting the ceramic igniter which could break preventing operation of the grill.
•The grill must be assembled as shown. The drip tray heat shields must be in place, and the burner must be properly positioned relative to the gas supply. Incorrect assembly of the grill may result in unsafe or hazardous conditions during operation.
•Do not leave the grill unattended while in use.
•Do not use charcoal briquettes or coals of any kind.
After removing all packaging materials, check to be certain that the grill components are correctly assembled in the grill box. The grill grates, stainless steel radiant and the burner are assembled in the grill box from the factory. Follow the steps below to assemble the com- ponents in the grill box.
A.Disassemble and/or remove the grill grate, stainless steel radiant and burner from the grill box.
B.Install the aluminum rectangular drip pan inside the grill box as shown below.
C.Install the heat deflector on grease drip pan handle and pins in front of the box.
D.Insert the end of the burner into the slots at the back of the grill box. Insert the tab on front of the burner into slot in the heat deflector.
E.The stainless steel radiant lies on two (2) studs on each end of the grill can.
F.Place the grill grate, with raised food containment rail oriented towards the grill box rear.
Exploded Views and Side View of Grill
Grill
Grate
Stainless
Steel Radiant
Spark igniter
Heat
Deflector
Grill Box
Drip Pan | Burner Placement in slots in back of grill |
Page 17
