WARNING SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
18.To Change Tall Oven Door Outer Panel
Remove oven door see 16. Lay door face down on a suitable surface and remove 2 screws from bottom edge of door and 2 screws from inside face of door.
Remove outer door panel. Remove door handle by unscrewing 2 screws. Remove 2
Fit panel to door. Reassemble in reverse order.
23To Remove an Oven element Thermal Cut-Out.
Disconnect from the electricity supply.
Pull the cooker forward to gain access to the cover box. Undo the cover screws and lift clear. The cutout is located on the earth plate beside the oven element connections. Disconnect the cutout wiring. Undo the fixings that secure the cutout to the earth plate and remove. Fit replacement control and
24. To Remove Oven Element.
19.To Change Tall Oven Door Magnetic Latch
Remove the control panel (see 4).
Remove the plinth (3 screws) and the central vertical cover (5 screws). Prize the retaining clip off the magnet unit. Fit new unit and retaining clip.
Reassemble in reverse order.
Check correct door operation.
20.To Remove Grill Element.
Disconnect from electricity supply.
Remove grill pan from grill chamber. From inside grill compartment remove enamelled front shield from grill roof, 2 screws and washers. Remove 2 screws and washers securing the grill element front support. Remove the screws from the grill elements.
Lift elements out carefully, disconnect the leads from the element terminals noting their position. If it is not possible to disconnect the leads in this way, pull cooker forward to gain access to the rear, remove screws securing the electric cover to the back sheet and remove cover and disconnect the terminals from the rear.
Fit new elements, reassemble in reverse order. Check operation of grill.
21. To Remove Oven Inner Back.
Open the oven door and remove the screws and washers securing the inner back to the back of the oven.
Carefully lift away the inner back. Reassemble in reverse order making sure that the 4 screws and washers are fully tightened.
Disconnect from electricity supply.
Remove oven inner back (see 22).
Remove 2 screws from the top of the element and 1 from the bottom of the element in side the oven. Lift element out carefully, disconnect the terminals connected to the element noting their positions. If it is not possible to disconnect the leads in this way, pull cooker forward to gain access to the rear, remove screws securing the electric cover to the back sheet and remove cover and disconnect the terminals from the rear.
Fit new element, and reassemble in reverse order. Check operation of oven.
25. To Remove the Left Hand Oven Bottom & Top Elements
Disconnect from the electricity supply.
Bottom Element
Pull the cooker forward to access the cover boxes at the rear of the unit. Remove the fixings that secure the cover and lift it clear.
22.To Change Fan in Oven.
Disconnect from electricity supply.
Pull cooker forward to gain access to the rear. Remove screws securing the electric cover to the back sheet and remove cover. Disconnect the 3 terminals connected to the fan noting their position. Remove oven inner back (see 20). Hold the fan blade and remove the centre nut (left hand thread) 2 brass washers, fan blade and Circlip. Unscrew fan retaining nuts and washers (3 off each) and lift the fan away from the rear of the cooker. Fit new fan and reassemble in reverse order. Check operation of oven.
Remove the 2 screws ‘A’ and allow the plate to drop down. Remove the 2 screws B, lower the upper plate and remove through the slot in the cooker back.
Undo the terminal connections, noting their positions.
35
