Rangemaster U109987 - 01 manual Warning - Servicing To Be Carried Out Only By An Authorised Person

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON

Disconnect from electricity before servicing. Check appliance is safe when you have finished.

9.To Remove the Grill Door

Remove the control panel (see 1). Remove the left-hand side panel (see 2). Remove the centre cover strip (5 screws, 2 top, 2 bottom, 1 in middle). Remove the two countersunk screws (1 each side) securing the grill hinge arms to the front of the grill chamber.

Note: The arms are spring tensioned. Carefully remove the grill door. Retain the gaskets.

Reassemble in reverse order ensuring that the gasket is fitted between the hinge arm and the front of the grill chamber.

10.To Remove Grill Element

Disconnect from electricity supply.

Remove grill pan from inside the grill compartment; remove the enamelled front shield from the grill roof, by undoing the two screws and washers.

Fig.8-1

ArtNo.216-0009 - Elan removing the handles

Fig.8-2 Fig.8-3

� �

Remove the two screws and washers securing the grill element front support. Remove the screws from the grill element.

Lift the element out carefully, disconnecting the leads from the element terminals (noting their position). If it is not possible to disconnect the leads in this way, pull the cooker forward to gain access to the rear, remove the screws securing the electric cover to the back sheet, remove the cover and disconnect the terminals from the rear.

Fit the new element and reassemble in reverse order. Check the operation of the grill.

11.To Replace an Oven Door

Open the oven door. Support the door and remove the two screws securing the upper hinge and gasket to the cooker front (Fig.8-2).Remove the door from the lower hinge by lifting slightly and moving outwards (Fig.8-3).

 The door is heavy, so take care.

Reassemble in reverse order.

12.To Adjust an Oven Door Angle

The bottom hinge of either oven door can be adjusted to alter the angle of the door (Fig.8-4). Loosen the bottom hinge fixing screws and use the notch and a flat bladed screwdriver to move the position of the hinge to set the hinge position (Fig.8-5).

Retighten the hinge screws.

13.To Replace an Oven Door Outer Panel

Move the cooker forward to gain access to the sides.

Open the oven door slightly and remove the front panel fixing screws from the door sides – two each side (Fig.8-6).

Carefully lift off the outer door panel.

Remove the two plastic blanking plugs from the door handle. Remove the door handle from the panel by unscrewing the two retaining nuts. Fit the door handle to the new panel and refit the two blanking plugs to the fixing holes.

Note: If replacing the outer panel on the right-hand door (with the Thermodial), take care to make sure the sensor of the Thermodial is sealed to the door by the rubber grommet (Fig.8-7).

Fit the panel to the door. Reassemble in reverse order.

ArtNo.320-0001 Door hinges ArtNo.320-0001 Door hinges

Fig.8-4

ArtNo.320-0006 Oven door hinge adjustment 1

Effect of hinge adjustment - exagerrated for clarity

Centreline of hinge pin Fig.8-5

ArtNo.320-0007 Oven door hinge adjustment 2

Oven door omitted for clarity

Fig.8-6

ArtNo.320-0002c

- Oven door side screws (Elan)

25