WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
8. Servicing
Disconnect the cooker from the electricity supply before servicing, particularly before removing any of the following: control panel, side panels, ceramic hob, or any of the electrical components or cover boxes.
Before reconnection, check that the appliance is electrically safe.
1.To Remove a Side Panel
Disconnect from electricity supply.
Pull the cooker forward. Remove the fixing screws.
Remove the retaining screws for each panel (one at the front, two at the rear, and one at each lower front corner of the side panels).
Reassemble in reverse order.
5.To Replace the Light Switch
Disconnect from electricity supply. Remove the control panel (see 1).
Note: The old switch may be destroyed during removal. Remove the old switch from its bezel by gripping the switch body behind the control panel and twisting sharply. Remove the switch bezel by folding back its locking wings and pushing forward. Fit the new bezel to the control panel by first lining up the raised key on its body with the
Assemble the new switch to the bezel by lining up the key sections and pushing home. Fit the new button by pushing in from the front.
Replace the Control Panel in reverse order and test for correct operation.
2.To Lift up the Ceramic Hob
Disconnect from electricity supply.
Remove the blanking plugs at the top front of each of the side panels to allow access to the hob fixing screws (1 each side) at the top of the side uprights. Remove these screws.
Lift up the ceramic hob at the front and prop in position with a
CAUTION: The ceramic hob material is much more sensitive to scratches on the underside than the top.
Take care not to touch or scratch the underside of the ceramic as this will weaken the material and cause the top to shatter.
6.To Remove the Electronic Timer
Disconnect from electricity supply.
Remove the control panel (see 1). Pull off the timer control button(s).
Remove the timer/mounting bracket assembly from the control panel by removing the fixing screws.
Remove the timer from its mounting bracket by depressing the plastic lugs on the timer case, at the same time pulling the unit forward.
Reassemble in reverse order. When replacing the leads, refer to the wiring diagram in this manual. Check the operation of the timer.
3.To Remove the Control Panel
Disconnect from electricity supply.
Remove the two blanking plugs from the handrail fixing brackets. Remove the handrail by unscrewing the 2 end bracket fixing screws
Pull off all the control knobs. Open the grill and
Lift the control panel, pull forward and disconnect the wiring from the rear.
Reassemble in reverse order. When replacing leads, refer to the wiring diagram in this manual. Check the operation of the timer.
4.To Replace a Hob Element
Disconnect from electricity supply.
Lift up the ceramic hob (see 2). The Induction Heating Elements (IHE) are now accessible. Note the wire connection positions and element orientation for
Note: The IHE will require commissioning when the hob has been refitted.
7.To Replace a Thermostat
Disconnect from the electricity supply.
Remove control panel (see 1) and lift hob (see 3). Open the oven door. Remove the oven furniture and slide out the oven roof liner if fitted.
For the
For the
Feed the thermostat capillary out of the oven. Disconnect the wiring from the thermostat. Remove two screws holding thermostat to mounting panel. Fit new thermostat and reassemble in reverse order. Ensure that the phial is clipped to the oven back with the phial centrally positioned between the clips.
Check the operation of the thermostat.
8.To Replace the Grill Controller
Disconnect from electricity supply.
Remove the control panel and lift up the hob (see 1 and 3). Disconnect the wiring from the controller. Remove the two screws holding the controller to the mounting panel. Fit the new controller and reassemble in reverse order. Check for correct operation.
24
