Zigzag, How do I follow a zig-zag pattern? | Raymarine D7637-1

How do I follow a zig-zag pattern?

When you enter ZIGZAG mode, the autopilot will use your current position and heading as the center line of the zig-zag. The autopilot will now gently steer your boat into the pattern starting with a turn to starboard.

press repeatedly until

MODE

you reach ZIGZAG

change pattern size (Sml, Med or Large)

activates autopilot

PILOT

in ZIG ZAG mode

1 2 3

From any screen:

1.Press MODE repeatedly until ZIGZAG is displayed.

2.Use the PORT and STARBOARD keys to change the size (S, M or L) if required

3.Press the PILOT key to activate the autopilot

ZIGZAG

Quick Tip

Fishing patterns are designed to work at speeds up to 15kts. Check your speed before starting.

D7621-1

User Guide	11

Image 15

Raymarine D7637-1 manual Zigzag, How do I follow a zig-zag pattern?

Contents

Raymarine S1000 Autopilot Page Alarms and Troubleshooting Contents Getting StartedUsing your S1000 Setting up your S1000 Important Information Getting started Changing the Controller batteries System Components Navigate Starboard S100 Autopilot Controller Operation modes How do I power the system on?Using fishing patterns Power saving mode Performance check Wireless signal strengthGPS filtering Keylock Using your S1000 System How do I use the autopilot? How do I automatically steer straight? Auto Mode How do I follow a route from my GPS? How do I follow a circle pattern? Circle How do I follow a zig-zag pattern? Zigzag How do I follow a cloverleaf pattern? Cloverleaf How do I dodge an obstacle? Setting up How do I change the pattern direction? You can change the default autopilot pattern direction How do I change my boat type? Press and hold Mode Press mode until the display reads Setup How do I adjust the autopilot settings? What is Rudder Gain? What is Counter Rudder? What is Auto Trim? What is Response? User Guide Alarms and Troubleshooting Alarm Message S1000 Alarm messages No GPS FIX Symptom Fault finding Frequently-asked questions Safety alarm General maintenance Cleaning the S1000 and S100Routine checks Dealer Maintenance Procedures Factory Reset To Register a handsetTo de-register a handset Product support User Guide Important Safety Information Safety Notices In-line power switchProduct installation Raymarine S1000 Autopilot FCC Information General Care and SafetyRadio frequency energy Exposure to radio frequency energy Waste Electrical and Electronic Equipment Directive Intended UseDeclaration of Conformity Disposal EMC Guidelines Handbook InformationConnections to other equipment