Raypak B-195 Continuation TROUBLE SHOOTING GUIDE, 5b. Ensure dishwasher operates correctly

Models: B-195

1 23
Download 23 pages 24.91 Kb
Page 17
Image 17
Continuation TROUBLE SHOOTING GUIDE

Continuation TROUBLE SHOOTING GUIDE

3d. Excessive vent exhaust or defective air/vent switch.

3d. Excessive negative pressure exerted by the exhaust system on the vent will prevent N.O. combustion air/vent switch from closing. Provide means to relieve pressure and close the N.O. switch. If combustion air/vent switch will not close, replace switch.

3e. Ignition module or igniter may be defective.

3e. Disconnect igniter leads from ignition module. Make sure 24V is present across ignition terminals on the igni- tion module during the ignition cycle. If not, replace ignition module. Check resistance reading across igniter leads. If circuit is open, or reading is greater than 30 ohms, replace the igniter. A new igniter will measure between 1 to 6 ohms at room tem- perature.

3f. Gas valve or the ignition module may be defective.

3f. During the ignition cycle, 24V should be present at the MV1 and GND termi- nals for about 5 seconds. If no 24V is measured, replace the ignition mod- ule. If 24V is present, replace the gas valve.

4.Unit energized, pump and blower running.

Ignitor is glowing.

Burners will not stay lighted.

4a.

Improper ground

4a.

Check ground connections inside

 

 

 

control box.

4b.

Loose wiring.

4b.

Check all connections and wire nuts.

4c.

Remote sensor

4c. Check wire connection to remote sen-

 

 

 

sor.

4d.

Insufficient gas pressure.

4d.

Check gas pressure at outlet of valve

 

 

 

under load, pressure should be:

 

 

 

3.5 in. W.C.for Natural gas

 

 

 

10.5 in. W. C. for Propane gas.

5Unit does not produce suffcient hot water

5a. Supply water temperature

5a. Ensure supply water temperature is at

too low.

least 140°F.

5b. Dishwasher times not set

5b. Ensure dishwasher operates correctly.

properly.

Check rinse cycle time and inspect

 

spray nozzles for correct pressure

 

setting or damage.

5c. Operating limit set too low.

5c. Adjust operating limit to minimum tem-

 

perature that provides 180°F rinse.

 

(Do not set above 185°F).

 

-Verify booster operates correctly, if

 

not, recheck all procedures listed

 

above.

17

Page 17
Image 17
Raypak B-195 installation instructions Continuation TROUBLE SHOOTING GUIDE, 5b. Ensure dishwasher operates correctly