Raypak B6000 manual Dip Switch Configuration, SW1 Modbus Port Configuration

11.3.0Hardware Setup

11.3.1.11500 Interface Card Setup

11.3.1.1Connecting Power to the T-3 Card

The T-3 Card requires an external source of DC voltage. The DC source voltage should be between 9V and 30V. The power is connected to TB1, located near the two 9 pin serial port connec- tions.

The connection to TB1 is as follows:

TB1-1	9-30 VDC (+)
TB1-2	Common (-)

11.3.1.2Dip Switch Configuration

The T-3 card is configured primarily through two sets of dip

switches. These switches are read initially on power up only. The function of the dip switches is as follows (a value of one (1) is registered when the a switch is in the ON position):

SW 1			1 2		3	4 5 6 7 8					OFF Position:		SW 2		O	1	2 3 4 5						6		7 8			OFF Position:
		O		•		•	•	•	•	•						•			•	•	•		•	•		•
															F
		F													F
		F
			•		•												•
											ON Position:				↓													ON Position:
		↓
												SW1 : Modbus Port Configuration
												Switch
												Position		Function											Positions
												1		Baud Rate				3					2		1
						2								Selection								0	0		0		300
						3												0					0		1		600
																		0					1		0		1200
																		0					1		1		2400
*	Factory Settings																	1					0		0		4800		*
																		1					0		1		9600 -
																		1					1		0		19200
9600, No Parity, Address Bit 1																		1					1		1		19200
						4								Parity				5					4			None -		*
						5								Selection							0		0
																		0					1			Odd
																		1					0			Even
																		1					1			Invalid
						6		Not Used
						7
						8

SW2 : Modbus Slave Address Configuration

Switch
Position		Function		Positions
1		Baud Rate	1	Address Bit 0	Value = 1	*
2		Address	2	Address Bit 1	Value = 2 -
3		Select	3	Address Bit 2	Value = 4
4			4	Address Bit 3	Value = 8
5			5	Address Bit 4	Value = 16
6			6	Address Bit 5	Value = 32
7			7	Address Bit 6	Value = 64
8	12		8	Address Bit 7	Value = 128