Temperature Sensors
The Aqua Logic utilizes 10K ohm thermistor type sensors. Two sensors (water temperature and air temperature) are included. If theAqua Logic is being used to control a solar heating system, a third “solar” sensor will be required. The sensors are provided with a 12 ft. cable. If a longer cable is required, contact the Goldline service dept.
POOL/SPA
SENSOR
AIR
SENSOR
SOLAR
SENSOR
Pool/Spa |
Air |
Solar |
Heater1 |
Heater2 |
Wired Remote Display/Keypad
The Aqua Logic main unit can connect to a maximum of 3 remote wired display/keypads. One remote wired display/keypad is included with theAqua Logic, additional wired display/keypads must be ordered separately.
Use four conductor cable (typically phone cable) to connect the wired remote display/keypad with the Aqua Logic Control Center as shown below. The maximum wiring distance is 500ft. (160m). Note that the terminals on both the Aqua Logic main unit and the wired remote display/keypad are numbered: Connect 1 to 1, 2 to 2, etc. Refer to diagram below.
Connect screw terminals “1” to “1”, “2” to “2”, etc.
1 | Aqua Logic Control Center |
2 | |
3 |
|
4 |
|
Wired Remote
Display unit
4 3 2 1 |
500 ft max
17