Raypak PS-4 PS-8 Configuration Setup, Accessing the Configuration Menu, Configuration Menu Items

5. Configuration Setup

After plumbing and wiring are complete, theAqua Logic MUST BE CONFIGURED before attempting to operate. Configuration information is entered at the keypad and “tells” theAqua Logic what equipment is connected and how each should be controlled.

Accessing the Configuration Menu

Configuring theAqua Logic requires that you navigate through the Configuration Menu and input various information. For more detailed information about using theAqua Logic menu system, refer to the Opera- tion Manual.

To access the Configuration Menu

Configuration Menu-Locked

Configuration

Menu-Unlocked

Menu		Press repeatedly until “Configuration Menu” is displayed
>	>	Press BOTH buttons SIMULTANEOUSLY for 5 seconds to unlock
>	>	Move to configuration menu items

NOTE: The configuration menu automatically “locks” after 2 minutes of no buttons being pressed to prevent unauthorized people from changing the control logic inadvertently and possibly damaging the pool equipment or causing a “call back” to fix the configuration.

Configuration Menu Items

Each item needs to be programmed and may contain additional sub-menu items. Refer to the following pages for information on programming.

Chlorinator

Enabled

+ Toggle between Chlorinator Enabled (default) and Disabled

>> Move to previous/next configuration menu item

Chlorinator

If the chlorinator is enabled (default) then the cell and flow switch must also be installed and the Aqua Logic will automatically chlorinate both the pool and spa according to the desired output setting (see Settings Menu in the Operation manual). If disabled, then neither the cell nor flow switch need to be installed and all displays relating to the chlorinator will be suppressed.

Filter Pump Config. + to view/change

Filter Pump

1 Speed

Freeze Protect

Enabled

+Push to access pump options

> > Move to previous/next configuration menu

+ Toggle between 1-speed (default) and 2-speed options

>> Move to next menu item

+ Toggle between Enabled (default) and Disabled Freeze Protection

>> Move to next menu item

Filter Pump

For 2-speed pumps: When a 2-speed pump is configured, one of the AUX relays must also be configured to control the low speed motor winding on the pump (see page 12 for wiring and page 23 for AUX configuration). See the Operation manual for specific information regarding the control logic for 2-speed pump operation.

Freeze Protection

Freeze protection is used to protect the pool and plumbed equipment against freeze damage. If freeze protection is enabled and the AIR temperature sensor falls below 38°F, the Aqua

19