RCA 1543007A manual Problem Solution

References

Trouble Checks

Sometimes problems can be easily solved by checking a few basic things. Check below before you call for help or take your TV/VCR to an Authorized RCA VCR Servicenter.

Problem	Solution
No power in AC mode	• Plug TV/VCR into an operating outlet.
	• Check connections.
	• Make sure the wall outlet is not controlled by a wall switch.
No power in DC mode	• Automobile cigarette lighter socket must be 12 volt negative ground system
	• Make sure cigarette lighter socket is working properly.
	• Check the fuse in the DC car cord.
TV/VCR does not respond to remote	• In DC mode, you must press the TV or VCR button for 3 seconds to turn on
	the set.
	• Aim remote at TV/VCR’s remote sensor with no objects between them.
	• Change batteries and make sure they are properly installed.
Poor or no picture during TV viewing	• Switch to an active channel.
	• Check antenna connections. If using a dipole antenna, try adjusting its rods.
	• Check picture adjustments. See page 8.
	• Make sure the line input is not selected. Repeatedly press 00 on the remote to
	switch between audio/video input jacks and tuner.
No sound	• Press VOLUME up to increase sound.
	• Sound has been muted. Press MUTE on remote or VOLUME up.
	• Check the external speaker switch on the back of the TV/VCR to ensure that
	it is in the correct position. See page
Snow or streaks in picture or no picture	• Check tape — it may be worn out or of poor quality. Try another tape.
during tape playback	• Some snow/streaks are normal during search, pause, frame advance, and
	slow-motion playback.
	• Press one of the TRACKING buttons on the remote or CHANNEL up or down
	on the TV/VCR to move the streaks up or down and out of the picture.
Will not record or play	• No cassette in TV/VCR.
	• Eject and re-insert cassette.
	• Broken tape — try another cassette.
	• Safety tab removed from cassette — TV/VCR will not record.
	• TV/VCR is in pause mode. Press PAUSE on the remote.
Cannot insert or eject tape	• Insert cassette with window facing up and safety tab facing out.
	• To remove cassette, TV/VCR must be connected to working outlet.
	• Turn POWER off and then on before trying to insert or remove cassette.
Time counter not working	• Press DISPLAY on remote to display time counter on screen. See page 18.
	• The time counter does not advance during unrecorded portions of tape.
	When an unrecorded segment of tape is encountered, the time counter will
	hold its count until recorded material is detected again.
	• A minus (–) will appear in front of the time counter if you rewind the tape
	farther back than a counter reading of 0:00:00.

Rewind does not operate

• Tape already rewound.

34