RCA 21028 manual Changing the Battery, Memory Full

Stop message playback	2
Erase message	0 (during message playback)
Skip message	3
Turn off/on answerer	4
Review voice menu options	7

MEMORY FULL

When answering system memory is full, the system answers after 10 rings, beeps and waits for you to enter the 3-digit security code. If you don’t enter the security code within 8 seconds, the phone hangs up.

You should erase some messages so the answering system can record new messages.

NOTE: The unit also answers after the 10th ring if it is turned off. To access the answering system, enter your 3-digit security code after you hear the beep.

CHANGING THE BATTERY

CAUTION: To reduce the risk of fire or personal injury, use only the battery 5-2522 that is compatible with this unit.

1.Make sure the telephone is OFF (not in talk mode) before you replace battery.

2.Remove the battery compartment cover.

3.Disconnect the cord attached to the battery pack from the jack inside the battery compartment and remove the battery pack from the handset.

4.Insert the new battery pack and reconnect the battery plug.

Battery

compartment

Battery pack

Battery pack

plug

Battery

compartment jack

5.Put the battery compartment cover back on.

6.Place handset in the base or handset charge cradle to charge. If you don’t charge the handset battery properly (for 16 hours) when you first set up the phone and/or when you install a new battery pack, the battery ’s long-term performance will be compromised.

44