RCA CC632 manual Playback Operation, Watch What the Camcorder is Seeing or Recording on the TV

Playback on a TV Without Audio and Video Inputs

Playback Operation

1.Set the channel selector switch on the RF output adapter to CH3 or CH4.

2.Turn on the TV and tune it to the same channel (3 or 4) you selected with the channel selector switch on the RF output adapter.

3.Press and hold the small button on the camcorder‘s POWER switch while sliding it to VCR.

4.Insert the cassette you want to play back into the camcorder.

Note: The camcorder can only play back tapes recorded at the SP speed.

5.Press PLAY on the camcorder. Adjust tracking on the camcorder, if necessary. Details are on page 43.

•During playback, use the playback features described on page 43.

6.Press STOP/EJECT on the camcorder when you are finished playing back the tape.

Watch What the Camcorder is Seeing or Recording on the TV

1.Turn on the TV and tune it to channel 3 or 4 (the same channel you selected with the CH3/CH4 switch on the RF output adapter).

2.Press and hold the small button on the camcorder’s POWER switch while sliding it to CAMERA. Insert the cassette you want to record on.

3.Press the camcorder’s REC/PAUSE button to begin recording. You can watch what the camcorder is seeing or recording on the TV screen.

Note: When the camcorder is used as a camera, turn the TV’s volume down to prevent a high-pitched squeal caused by feedback.

Normal TV Viewing

For normal TV viewing, you can leave	from the camcorder or turn the
the RF output adapter hooked up to the	camcorder’s power off.
TV. Just disconnect the adapter’s plug

Note to Cable-TV Installer: This reminder is provided to call your attention to Article 820-40 of the National Electrical Code (Section 54 of Canadian Electrical Code,

Part I), that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical.

47