RCA DTC210 user manual Setting the dish type manually, To set the dish type manually

Connections & Setup

Setting the dish type manually

To function properly, your DIRECTV® HD Receiver needs to know what type of satellite dish you are using. You can set the dish type manually using the instructions below. See the next page for information on how to set the dish type automatically.

Note: For access to DIRECTV® High-Definition programming, you will need an oval, triple

LNB satellite dish antenna.

To set the dish type manually:

1.If the progress screen (shown on the left) is on your TV screen, select Installation by pressing SELECT.

If this screen is not displayed, access the main menu by pressing MENU on your remote. Then use the arrow buttons on your remote to highlight SYSTEM SETUP and press SELECT. Then highlight Installation and press SELECT (the Installation menu appears).

2.Highlight Dish Setup and press SELECT (the Dish Setup menu appears).

3.Highlight Select Dish Type and press SELECT (the Select Dish Type screen appears).

4.Use the right-arrow button to highlight Dish Type on the Select Dish Type screen.

5.Use the up- and down-arrow buttons on your remote control to display the dish type you are using (Round, Oval-2, Oval-3, or No Dish). As you display each dish type, the on-screen pictures update showing you what each of these dish types look like.

If you plan to use your HD Receiver for local off-air or cable TV programs, but do not plan to receive DIRECTV® programming, select No Dish.

6.When you have displayed the correct dish type, use the right-arrow button on your remote control to highlight OK, then press SELECT. A message appears warning you that your HD Receiver needs to reboot (turn itself off and on) for the Dish Type setting to take effect.

7.To change the dish type to the new setting, highlight OK and press SELECT on your remote. Your receiver will reboot.

To leave the dish type setting unchanged, highlight Cancel and press SELECT on your remote.

If you selected No Dish, the HD Receiver will perform an auto-scan to put your cable and off-air channels into its memory so you can tune them and see them in the on-screen guide.

Chapter 2 25