RCA DTC210 user manual Back Panel Switches and Input/Output Jacks

Additional Information

Back Panel Switches and Input/Output Jacks

The diagram below illustrates the location of the input and output jacks on the back of the DIRECTV® HD Receiver. Step-by-step setup instructions for connecting your HD Receiver appear in Chapter 2.

�������������� �������

�����

	�����	���������
		������
������	��������
		���
����		��
		�
�������
		�����������������

������������������� ������������������������

�������������������	���������	�����	�������	�����
			�����
			���������

AIR IN Connect your off-air TV antenna to this jack. Both standard analog (NTSC) and high definition digital (ATSC) program broadcasts can be received through a single antenna connected to this jack.

SATELLITE IN Connect the RG-6 cable from your satellite dish to this jack.

CABLE IN Connect the RG-6 cable from your cable TV provider (if you have one) to this jack. This input is intended for use with a cable NTSC signal only. It is not intended (nor does it support) off-air signals.

VCR CONTROL Connect the VCR control cable to this jack. Attach the other end of the cable to your VCR's IR receiver (see Chapter 2 for more information).

S-VIDEOThis jack connects your DIRECTV HD Receiver to a TV or VCR that accepts S-Video input.

IR IN This jack is used to connect a wired remote control system, which is primarily for professional installers. If you’re using the remote that was included with your TV, don’t plug anything into this jack.

OUT TO TV Using an RF coaxial cable, this jack provides a basic connection between your HD Receiver and your TV or VCR.

VIDEO Using standard video cables, these jacks connect your DIRECTV HD Receiver to your TV or VCR.

AUDIO (L1, R1, L2, R2) Using standard stereo audio cables, these jacks provide stereo audio to your TV, VCR, or A/V receiver.

DIGITAL AUDIO (OPTICAL) Using an optical digital audio cable, this jack allows you to connect your HD Receiver to an A/V receiver that accepts optical digital audio input.

RGB OUT Using an RGB monitor cable, this jack connects your HD Receiver to a TV that accepts high-definition RGB video input.

DVI with HDCP OUT Using a digital DVI cable, this jack connects your HD Receiver to a TV that accepts the unconverted DVI signal from a high-definition digital broadcast (from satellite, or antenna). This jack supports HDCP content protection. (For the best access to high-definition programming, connect this output to the corresponding DVI/HDCP input that supports HDCP technology on your HDTV Monitor.)

70 Chapter 6