Test the System
The testing and initial programming of components can be done at the component or by remote control. Conduct these tests before moving the TV into position.
Note: Unless otherwise noted, all remote control references in this guide will be referring to the system remote control which came packed with the audio/video receiver. Install the four “AAA” batteries that came packed with the remote.
➤Test the Audio/Video Receiver and Speakers
The audio/video receiver tunes the audio signals for AM and FM radio reception and controls the audio inputs and surround modes for the TV, VCR, LaserDisc and CD player.
Note: See the audio/video receiver’s use and care guide for complete operating information.
❑1. Turn off the TV’s internal speakers. Press TV to turn on the TV and audio/video receiver and set the remote to operate the TV. Repeatedly press TV MENU on the remote to select Audio Menu. Then press + or – to display the audio functions.
Mute
Video Menu
Audio Menu
Setup Menu
❑2. Repeatedly press TV MENU on the remote to select Speakers: On. Then press + or – to turn off the TV’s internal speakers.
Balance
Stereo/SAP: Stereo
SRS: Off
SRS Width: Off
Speakers: Off
❑3. Adjust the volume by pressing VOLUME up or down on the remote or turn the VOLUME control on the receiver.
❑4. In order to test the speakers, the audio mode on the receiver must be set to PRO LOGIC. Repeatedly press SUR MODE on the remote or SURROUND MODE on the receiver to set the audio mode to PRO LOGIC. The indicator next to PRO LOGIC on the receiver will light.
Note: If the audio mode does not change when you press SURROUND MODE, press BYPASS on the receiver, and then press SURROUND MODE again.
❑5. Press TEST on the audio/video receiver to generate the test tone (pink noise). Check the volume level of each speaker as the noise moves clockwise from one channel to another automatically. (If front surround speakers were added to the system, press FRONT to apply the pink noise to these speakers.)
Note: Both rear surround speakers will have the test tone on them at the same time.
❑6. Press the appropriate speaker source button (FRONT, CENTER, or REAR), and then press + or – to adjust level. Press TEST again to end the test.
Note: Pressing FRONT is for adjusting front surround speakers if connected. To adjust the front right and left speakers, you must use the amplifier’s volume control.
❑7. Press AUDIO SHIFT, then FM/AM on the remote or AM/FM on the receiver to activate the AM/FM tuner.
20
