RCA manual Installing TV on Suspension Arm - J12H770-DV3 / J12H770-DV4, Connections and Setup

Chapter 1: Connections and Setup

Installing TV on Suspension Arm - J12H770-DV3 / J12H770-DV4

The J12H770 is designed to attach to a wall mounted suspension arm capable of supporting a television weighting 14 pounds. The single coaxial cable on top of the unit is used to supply either low voltage DC power (24 volts) and the RF signal to the television.

Male RF Cable

Female 3.5mm Stereo Cable (RS232C)

Male 3.5mm Cable

(Y, Pb, Pr)

Male DC 5V Jack

Male 3.5mm Cable (Audio)

DANGER: ARM RECOIL HAZARD The safety brake pin must remain in the SAFETY BRAKE PIN HOLE whenever the television set is removed from the arm or when the arm is removed from the wall bracket to prevent the arm from springing open.

CAUTION: DO NOT REMOVE the Beige silicon cover from the swivel assembly. This swivel assembly is factory preassembled and adjusted. There is no need to remove the cover.

IMPORTANT: These instructions detail installing the TV onto the FC-80 suspension arm. This arm is configured specifically for this television. The J12H770 may be installed on other FC Series arms.

Chapter 1 11