RCA J20F635 manual Start-up, Plug in the TV, Put Batteries in the Remote, Turn on the TV

Connections & Setup

• TV ANT Used to attach either an antenna or cable system to the TV. To connect a VCR, connect a coaxial cable to the TV ANT jack on your TV and to the Output Jack on the VCR (sometimes labeled OUT TO TV).

TV ANT

Plug in the TV

•R and L/MONO AUDIO and VIDEO Their description is the same as VIDEO 1.

AUDIO/VIDEO OUTPUTS Allow connection of external audio amplifiers, power speakers, audio receivers for improved sound quality or an external video monitor with the use of VIDEO OUT. Please note that these outputs cannot drive standard speakers directly.

DSCI PORT This port is used to transfer information between a TV and other devices, such as a clone box or interactive system. This port is an eight-pin telephone-type port. When the TV receives a message via the DSCI (digital serial communications interface) port, it will act in accordance with the digital instructions received. For more information on its connection and operation, please contact your distributor or the supplier of the interactive system.

Plug the end of the power cord into a grounded wall outlet. Insert the plug completely into the outlet.

Start-up

The steps below get your TV connected and ready to watch.

Put Batteries in the Remote

1.Slide off the cover of the battery compartment.

2.Place the two AAA batteries into the remote, matching the + and – end of each battery in the compartment.

3.Replace the cover.

Turn on the TV

Press POWER on the TV or remote.

8 Chapter 1