RCA pp18l, RCU450 manual Program for VCR Direct Entry Method

Program for VCR—

Direct Entry Method

In order for the four component universal remote to control your VCR, you must program it with the code that matches your VCR. These instructions explain the preferred method of programming the remote—the Direct Entry method.

CODE

SEARCH

1.Manually turn on the VCR.

2.Locate the enclosed VCR Code List. Find your brand of VCR.

Note: If your brand isn’t listed, use one of the Code Search methods to program this remote control (See Code Search on page 9).

1 2 3

4 5 6

7 8 9

0

ON•OFF

VCR CODE

3.Press and hold the CODE SEARCH key for approximately three seconds until all four component keys light up. Then release the CODE SEARCH key.

4.Press and release the VCR key. The VCR key remains lit.

5.Use the number keys on the remote to enter the first code listed for your brand.

After you enter a valid 3-digit code, the component key light turns off.

Note: If you enter an invalid code, the lighted component key will flash rapidly. Start over at step 3.

6.Aim the remote at the VCR. Press the ON•OFF key. If your VCR turns off, you have found the correct code.

7.Enter the code in the box provided on this page for future reference.

8.If your VCR doesn’t turn off, repeat steps 3-6 above, entering the next code for your brand.

If none of the codes work or your brand is not listed, use one of the Code Search methods to program this remote (See Code Search on page 9).

For a description of each key on the remote control, refer to the Key Descriptions section on page 3-4.

6