Program for DVD•AUX—
Direct Entry Method
In order for the four component universal remote to control your DVD player or auxiliary component, you must program
it with the code that matches your component. The DVD•AUX key can be programmed to operate a DVD player or a second TV, VCR, DBS or cable box. These instructions explain the preferred method of programming the
CODE
SEARCH
1 2 3
4 5 6
7 8 9
0
ON•OFF
DVD•AUX CODE
✓ TV VCR CABLE DBS DVD
1.Manually turn on the component you wish to assign to the DVD•AUX key (TV, VCR, DVD, DBS System or Cable Box).
2.Locate the enclosed DVD code list, or the corresponding code list for the auxiliary component (TV, VCR, DBS, or cable box).
Note: If your brand isn’t listed, use one of the Code Search methods to program this remote control (See Code Search on page 9).
3.Press and hold the CODE SEARCH key approximately three seconds until all four component keys light up. Then release the CODE SEARCH key.
4.Press and release the DVD•AUX key. The DVD•AUX key remains lit.
5.To program for DVD, press the
VCR key. For an auxiliary component, press the corresponding component key (TV, VCR, DBS•CABLE).
The DVD•AUX key will blink, then remain lit.
6.Use the number keys on the remote to enter the first code listed for your brand.
After you enter a valid
Note: If you enter an invalid code, the lighted component key will flash rapidly. Start over at step 3.
7.Aim the remote at your component and press the ON•OFF key. If your component turns off, you have found the correct code.
8.Enter the code in the box provided on this page for future reference.
9.If your component doesn’t turn off, repeat steps
If none of the codes work or your brand is not listed, use one of the Code Search methods to program this remote (See Code Search on page 9).
For a description of each key on the remote control, refer to the Key Descriptions section page
8
