RCA RS27116I CD Playback, Sleep Timer Setting, Listening to Your iPod, Display Function

CD Playback

1.Press the STANDBY/ON button to turn on the unit.

2.Slide the OPEN knob to open the CD door. Place a disc in the center with the label side front and then close the CD door gently.

3.Press the FUNCTION button to CD mode. “- -” will blink on the display. Then the total track no. is shown on the display.

4.Press the PLAY/PAUSE button to start playing.

•Adjust the volume levels.

To Pause Playback

•Press the PLAY/PAUSE button.

•To resume playback, press the PLAY/PAUSE button again.

To Stop Playback

•Press the BAND/ STOP button.

Skipping to Another Track

•Press either the or button according to the desired direction.

Press the button to skip to the start of the current track or skip

to previous tracks. Press the button to skip to the beginning of

the next track.

Locating a Particular Point on a Track

•Keep either the or button pressed during playback, according to the desired direction, and release at the desired point.

repeat playback

Repeat Current Track

•Press the MEM.UP/ button until“REPEAT” blinks on the display. The current track will be played repeatedly.

Repeat the Entire CD

•Press the MEM.UP/ button until“REPEAT”stops blinking and remains on. All tracks will be played repeatedly.

Cancel Playback Mode

•Press the MEM.UP/ button until repeat indicator disappears.

RANDOM playback

All tracks on the disc can be played in random order (Using the remote control only).

Random Playback
• Press the RANDOM button on the remote	RANDOM
control and “RANDOM” will be shown on the
display. All tracks will be played randomly.
After all tracks have played, the unit will stop
automatically.

- 8 -

Timer Setting

The timer function will turn the unit on at a preset time.

To Set Timer

1.In standby mode, press and hold the TIMER button on the remote control until the TIMER indicator blinks.

2.Press and hold the PROG/MEM/ () button until the hour digits blink.

3.Press the or button to adjust the desired hours then press the PROG/MEM/ () button once to confirm. The minute digits will begin to blink.

4.Press the or button to adjust the desired minutes then press the PROG/MEM/ () button once to confirm. Thetimer indicator will stop blinking and remain on.

5.The unit will wake up to “RADIO”, “ iPod” ,“AUX IN” or “CD” when the timer reaches the preset time.

•For RADIO timer, first tune in to a desired station.

Press the STANDBY/ON button to enter standby mode, then set the timer following the above steps.

•For CD timer, first press the FUNCTION button to CD mode and insert one CD into the unit.

Press the STANDBY/ON button to enter standby mode, then set the timer.

•ForAUXINtimer,firstconnecttheplugtotheAUXINjackinbackpanel.Press the STANDBY/ON button to enter standby mode, then set the timer.

•For iPod timer, first insert your iPod into the connector, Press the

FUNCTION button to iPod mode. Press the STANDBY/ON button to enter standby mode, then set the timer.

Note: Before setting timer, you can adjust the volume levels in RADIO/ CD/iPod/AUX IN mode for the timer.

To Cancel Timer

•Press and hold the TIMER button on the remote control until the

TIMER indicator goes out.

Sleep Timer Setting

The sleep timer automatically turns the unit off after a certain time.

1.While the unit is on, press the SLEEP button and “ ” appears on the display.

2.Press the SLEEP button repeatedly to select the desired sleep time as below:

3.The unit will automatically turn off once it counts down the sleep time.

•To clear the preset sleep time press the SLEEP button until “00 ” appears.

-12 -

811-711691W062 ENG RCA.indd 2

CD Playback

Cancel Random Playback

•Press the RANDOM button on the remote control again during

RANDOM playback to return to normal playback.

Programmable CD Playback

A program of up to 20 tracks can be set to play in a preset order.

1.	In CD stop mode, press the PROG/MEM/			MEMORY
	( ) button and “MEMORY” & “- -” will blink on
	the display.	or	button to select the desired
2.	Press the

track then press the PROG/MEM/ () button to store the track in memory.

3.To add additional tracks, repeat step 2 (up to 20 tracks).

4.To start playback, press the PLAY/PAUSE button.

To check the program:

•Press the BAND/ STOP button and the or button. Each time

the button is pressed, the track number appears on the display.

To change the programmed tracks during program playback:

•Press the BAND/ STOP button and press the PROG/MEM/ () button repeatedly to search the program number, then press either

the or button to select the desired track. Press the PROG/ MEM/ () button again to register the newly selected track into program.

To erase the whole program, do one of the following:

•Press the FUNCTION button to change to radio/iPod/AUX mode.

•Press the STANDBY/ON button to turn off the unit.

•Press BAND/ STOP button repeatedly until “MEMORY” disappears.

Listening to Your iPod

Compatible iPod Types

•iPod nano (1st generation) 1GB, 2GB, 4GB

•iPod nano (2nd generation) 2GB, 4GB, 8GB

•iPod nano 3rd generation (video) 4GB, 8GB

•iPod nano 4rd generation (video) 8GB, 16GB

•iPod 5th generation (video) 30GB, 60GB, 80GB

•iPod classic 80GB, 120GB, 160GB

•iPod touch (1st generation) 8GB, 16GB, 32GB

•iPod touch (2nd generation) 8GB, 16GB, 32GB

Note: Also supports iPhone when iPhone is set to “airplane mode”.

- 9 -

Display Function

CD mode

1.During playback, press the DISPLAY button repeatedly to shuffle between the CD playback mode and the current time.

2.When stopped, press the DISPLAY button to shuffle between the total number of CD tracks and the current time.

Radio/iPod/AUX Mode

•Press the DISPLAY button to shuffle between the current playback mode and the current time.

Troubleshooting Guide

Problems	Solutions
CD
System does not	•	Make sure AC adapter is secure in the outlet, and outlet
turn on		has power.
	•	Make sure you’ve selected CD mode.
Disc in place but	•	Make sure disc label is facing front.
unit won’t play	•	Make sure disc is clean.
	•	Pause mode is activated.
	•	Disc may be damaged or dirty; check disc.
Disc skips	•	Make sure the unit is on a secure spot. Vibration or
RADIO		jarring can cause the disc to skip.
Poor FM reception	•	Make sure FM antenna wire is fully extended.
	•	Electrical interference in your home can cause
		poor reception. Move the unit away from them
		(especially those with motors and transformers).
Poor AM reception	•	Rotate the unit horizontally.
iPod
iPod does not dock •		Remove your iPod from the dock and check for
properly or does not		obstruction on the connectors in the dock and on
install properly.		your iPod.
iPod does not	•	Make sure that your iPod is working properly before
respond to the		docking into the unit. Please refer to your iPod
speaker system.		manual for details.

Maintenance

Cleaning the Unit

Do not use volatile chemicals on this unit. Clean by lightly wiping with a soft cloth.

Cleaning the CD

If the CD skips or will not play, the disc may need to be cleaned.

Before playing, wipe the disc from the center outwards with a cleaning cloth. After playing, store the disc in its case.

Handling the disc

Only touch the CD on the edge to avoid finger prints on its surface. Do not stick paper or tape nor write anything on the surface.

- 13 -

Listening to Your iPod

Installing an iPod Dock Adapter

1.Before connecting your iPod, it’s recommended that you install the appropriate iPod Dock Adapter (supplied

with the iPod or sold separately) in the dock
of the unit.
2. InsertyouriPodDockAdapterintothedock
until it sits firmly in place.	iPod Dock Adapter
Removing the iPod Dock Adapter

1.Remove the iPod Dock Adapter as illustrated in the figure to the right.

2.Replace it with another one you need.

Inserting Your iPod

1. Insert your iPod into the connector in the dock.

2.Press the STANDBY/ON button to turn on the unit.

3.Press the FUNCTION button repeatedly until the indicator “iPod” appears on the display.

4.Press the PLAY/PAUSE button to start

playing.

Notes:

•The iPod will charge automatically (until fully charged) once it is docked in the cradle.

•To prevent interference to AM radio signals, please switch off the iPod while listening to AM stations.

Pausing Playback

•Press the PLAY/PAUSE button.

•To resume playback, press the PLAY/PAUSE button again.

Skipping to a Another Track

•Press either the or button according to the desired direction.

•Press the button to skip to the beginning of the current track or previous track. Press the button to skip to the beginning of the next track.

Locating a Particular Point on a Track

•Keep either the or button pressed during playback, according to the desired direction, and release at the desired point.

Repeat Playback

Repeat lets you play songs repeatedly (a single repeat or all songs repeat).

- 10 -

Limited Warranty

AVC MULTIMEDIA ("AVC") makes the following limited warranty. These limited warranties extend to the original consumer purchaser and is limited to non-commercial user of the product.

One Year Parts & Labor Warranty

AVC products purchased in the United States are warranted to be free from defects in materials or workmanship for a period of one year from the date of their original retail purchase. If the unit fails to conform to this warranty, we will service the product using new or refurbished parts and products, at AVC's sole discretion.

During a period of one year from the effective warranty date, AVC will provide, when needed, service labor to repair a manufacturing defect at its designated Service Center. To obtain warranty service in the United States, you must first call our Customer Support Center at 1-800-506- 5746 or 1-877-252-6873, during the hours listed in the box below. The deternination of service will be made by AVC customer support.

PLEASE DO NOT RETURN YOUR UNIT TO AVC WITHOUT PRIOR AUTHORIZATION. New or remanufactured replacements for defective parts or products will be used for repairs by AVC at its designated Service Center for one year from the defective warranty date. Such replacement parts or products are warranted for an additional one year from the date of repair or replacement. The Customer will be required to ship the unit to the Service Center indicated at the time Customer Support is contacted to make the necessary repairs. The customer is responsible for all transportation charges to the service facility.

Packaging and Shipping Instruction

When you send the product to the AVC service facility you must use the original carton box and packing material or an equivalent as designated by AVC.

Your Responsibility

(1)You must retain your bill of sale to provide proof of purchase.

(2)These warranties are effective only if the product is purchased and operated in the U.S.A. or Canada.

(3)Warranties extend only to defects in material or workmanship, and do not extend to any product or parts which have been lost or discarded, or damage to product or parts caused by misuse, accident, improper operation or maintenance, or use in violation of instructions provided with the product, or to product which has been altered or modified without authorization of AVC, or to products or parts thereof which have had the serial number removed or changed.

Out of Warranty

In the event your product requires repair after the limited warranty period has expired, please contact our Customer Support Center at 1-800-506-5746,1-877-252-6873or

www.RCAav.com

Hours: Monday-Thursday: 9am-7pm, Friday: 9am-5pm, Saturday: 9am-NOON Eastern time.

Important:

You are responsible for any transportation, shipping or insurance relative to the return of the product to our Product Returns Center.

- 14 -

Listening to Your iPod

•Press the MEM.UP/ button on the remote control. The repeat indicator appears on the iPod screen.

•To cancel repeat playback, press the MEM.UP/ button until the repeat indicator disappears.

Note: Please refer to the owner’s manual that was included with your iPod for more details.

Random Playback

Random plays songs/albums from your iPod in a random order.

1.Press the RANDOM button on the remote control once and the random indicator appears on the iPod screen. All songs will be played without sequence.

2.Press the RANDOM button on the remote control twice and the random indicator appears on the iPod screen. All songs of this albums will be played without sequence.

•To cancel shuffle playback, press the RANDOM button until the shuffle indicator disappears.

Note: Please refer to the owner’s manual that was included with your iPod for more details.

Preset EQ

This system supports a variety of equalizers and sound effects.

During playback, press the PRESET EQ button to select a desired music mode. Each time the PRESET EQ button is pressed, the music mode will be changed to the next one as follows:

-> (ROCK) -> -> (CLASSIC)

AUX IN Connection

Connecting to AUX IN for other sound sources

You can connect audio devices such as your iPod, CD players, MP3 Players, or PC to the unit via the AUX IN jack. To do this, connect an audio cable with 3.5mm plugs from the line out or headphone out jack of the other audio device to the AUX IN jack on the unit’s back panel.

Listening to the Connected Device

1.Press the FUNCTION button to AUX IN mode and “AU” is shown on the display.

2.Turn on the audio device you’ve attached to the AUX IN jack.

- 11 -

Limited Warranty

All warranties implied by state law, including the implied warranties of merchantability and fitness for a particular purpose, are expressly limited to the duration of the limited warranties set forth above. With the exception of any warranties implied by state law as hereby limited, the foregoing warranty is exclusive and in lieu of all other warranties, guarantees, agreements and similar obligations of manufacturer or seller with respect to the repair or replacement of any parts. In no event shall AVC be liable for consequential or incidental damages.

No person, agent, distributor, dealer or company is authorized to change, modify or extend the terms of these warranties in any manner whatsoever. The time within action must be commenced to enforce any obligation of AVC arising under the warranty or under any statute, or law of the United States or any state thereof, is hereby limited to one year from the date of purchase. This limitation does not apply to implied warranties arising under state law.

This warranty gives you specific legal rights and you may also have other rights, which may vary from state to state. Some states do not allow limitation on how long an implied warranty lasts, when an action may be brought, or the exclusion or limitation of incidental or consequential damages, so the above provisions may not apply to you.

For more information on other products and services, please contact our web site at www.RCAav.com

Important: Also keep your “Bill of Sale” as proof of purchase.

Model no	Product name
Type of set
Serial no	Invoice no
Date purchased	Dealer name

FOR SUPPORT, SERVICE AND REPAIR, PLEASE VISIT www.RCAav.com

Specifications and external appearance are subject to change without notice.

Need More Help?

Please visit online help at http://www.RCAav.com

Printed in China 811-711691W062

2009-05-22 15:05:35