9 – Specifications : Dimensional drawing
Dimensional drawing
| MM v |
MM v | MM v |
| MM v |
MM v |
|
MM v |
|
Figure 9.1: Dimensional drawing
Messages and troubleshooting
This provides an alphabetical list of the messages that you may see on the
Not all of these messages are error messages.
“Information” messages, i.e. those which pop up briefly and provide information about a change in status, etc., are marked with a ●.
“Confirm” messages, where a response may be nec- essary (usually confirm with the ENTER key or can- cel with the cursor keys) are marked with a ✔.
Messages demanding action other than a simple con- firmation are shown with a (✖), but even these do not necessarily indicate an error.
Action | Message | Meaning |
|
|
|
● | Already assigned. | The RECORD key has already been assigned to a remote unit. |
✖Automation data and Current Status use The automation data uses a sampling frequency of a different value from the
| different Fs. | current sampling frequency. |
| Press ENTER to continue. |
|
|
|
|
✖ | Automation data and Current Status have | The automation data uses a timecode of a different frame type from the current |
| different | timecode. |
| timecode types. |
|
| Press ENTER to continue. |
|
|
|
|
● | Automation data was recalled. | The selected automation data has been recalled into memory. |
|
|
|
● | Automation data was stored. | The current automation data has been stored to card. |
|
|
|
✔ | AUX | Used when batch copying parameters from channel to Aux |
Set up Ch parameters? |
| |
|
| |
| Press ENTER to confirm, |
|
| or a cursor key to cancel |
|
|
|
|
|
| Table 9.2: Popup messages |
TASCAM